I got a '94 Buick Skylark Custom Sedan, but all are the same, first pull your back seat down, just grab it and jerk it and it will fold down where you can work. Then take a knife and pop the black plastic bolts holding the cover on in the back window, this covers the whole back. Then just unscrew the screws holding the speaker in, and then lift out. That's it.
4x6 hard to replace!!!
a 1991 buick skylark has 4" speakers in the dash and 6x9's in back
how do you replace the alternator in a 97buick skylark
how do you replace a ignitionswitch tumbler 1991 buick skylark
you replace it by...hold on
How do you replace the water pump and where is it located on a 1996 Buick Skylark V6
They can take 5 1/4 inch speakers. 4 x 6 speakers fit too.
remove cover, unscrew, disconnect
can i do this at home
they used 4"x10"
Ignition what? Switch? Coil?
Anything with less torque; or almost everything.
It depends on the model year but usually the back speakers are 6 x 9 and the front are 5 1/4. Check with Crutchfield.com to be sure.
You take it out and put a new one in
You could either do it the hard way by taking out the back seat (no kidding) or you can empty out your trunk, get some pliers and twist the screws on the speakers upwards and remove them through the open space that way (again, no kidding). I have a '95 Skylark and it worked that way when I replaced my speakers. Use #4 bolts, nuts and lockwashers when putting the new speakers in. The trickiest part is getting all 4 bolts through the 4 holes at once.
you have to take the timing chain off
Try Crutchfield.com for installation kits.
who knows i have the same question
Big job!! get a manual on your car.
Just remove pan and change bearings.
Maybe $100 tops....
It can cost between $80 and $300 to replace the fuel pump in this car. It will depend on where a person gets the part and who does the replacing.
To a Skylark was created in 1820.
To a skylark is an Ode.