Fuel and Engines
Ford Probe
Check Engine Light
Combustion Engines

You washed your 97 ford probe and now the engine is idling really low you think there is water in the engine how do you get it out?

8910

Top Answer
User Avatar
Wiki User
2007-05-18 12:21:50
2007-05-18 12:21:50

water could have gotten into the spark plug holes. water + spark= no good. Only a few spark plugs could be firing, take them out, and check for water.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

i found that in mine, it was the egr actuator

User Avatar

its a Mazda engine . ( DOHC 4cyl. 16 valve 2.0l ) For the probe 1993

User Avatar

On the back right side of the engine. Its really hard to see.how do you hook it up

User Avatar

stock enginestock engine in 1994 ford probe GT is a Mazda 2.5L 24 valve V6.

User Avatar

Japanese Motor that is frequently engine swapped into a Ford Probe.

User Avatar

No, a probe is a robot, so it's not really living.

User Avatar

Yes , according to the Gates website the 2.0 liter 4 cylinder in a 1996 Ford Probe IS an interference engine

User Avatar

Yes , according to the Gates website ( they make timing belts etcetera ) the 2.0 liter four cylinder engine in a 1996 Ford Probe ( is an interference engine )

User Avatar

The biggest engine you can fit in a probe is the engine out of the Ford Taurus SHO. I believe it is either 3.0 or 3.2 and requires a lot of modification to fit.

User Avatar

The 2.5l 6 cylinder engine is the original engine in a 1994 ford probe gt and in the se and base it is a 2.0l 4 cylinder engine

User Avatar

no, the 89-92 engine/transmissions are different from the 93-97 ford probe.

User Avatar

Yes, the 2.0 liter 4 cylinder engine in a 1996 Ford Probe is an interference engine ( according to the Gates website , they make timing belts etc. )

User Avatar

The ford probe gt does not have a block heater block heaters are normally on a desiel Engine

User Avatar

No , according to the Gates website ( they make timing belts etcetera ) the 2.0 liter four cylinder engine in a 1997 Ford Probe ( IS AN INTERFERENCE ENGINE )

User Avatar

None. The engine is an Mazda 626 V6 2.5 L.

User Avatar

the local salvage yard. They are also the same engine as the ford probe

User Avatar

if its a v6 then its right on top of the engine. but its i4 then its behind the engine.

User Avatar

The engine coolant drain plug in the 1996 Ford Probe 4-cylinder is located at the bottom end of the radiator. There is a coolant reservoir at the top of the engine as well.

User Avatar

it really sucks youll break at lease 4-5 fingers! but you should definitely invest in a hanes or chiltons manual they are very helpful!

User Avatar

ford probe is the same engine/transmission configuration

User Avatar

nobody really know's when the first space probe was created. But it was launched on october 4 1957

User Avatar

if you pull out one of the wires turn the car on while its idling you should hear a clicking coming from the spark plug well

User Avatar

between the engine and the drive wheels

User Avatar

Yes,but the 93 and 94 enginges are obd1,while the 95-97 are obd2.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.