answersLogoWhite

0


Best Answer

wiring fried and melted together under driver kick panel, It was caused be a screw that holds down the plastic floor panel..

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Your 1992 e150 has a problem with the right turn signal the right one stays on even with the van off when you hooked the batt up today there was smoke pouring out from the dash can anyone help?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

There is no signal being sent to the cpi on your 1993 blazer there is orange spark at the plugs engine obviously will not fire any ideas why there is no signal to the injector?

I have the same problem, if pouring fuel to the throttle body it will start and run, when hot it will not start even with fuel in throttle body.


When you use your left turn signal your high beams come on unless you pull the lever towards you and hold it has anyone else come across this problem and how could you fix the problem?

Sounds to me like you need a new turn signal switch.


Can you plug it your directv to a projector?

It's a TV PROJECTOR it Projects any video signal that is hooked up to it.


Can an Internet cable modem be hooked up after a power booster is hooked up for signal?

It may work but it is not advisable. Could cause disconnects and packet loss which would interfere with Internet access.


When you turn right signal on the left signal gets brighter and the right signal light goes out?

You have a problem with your ground. A weak ground will always cause this type problem.


My brother-in-law has recently bought Samsung LED TV. But when I tried it I felt that the picture is getting blurred. Can anyone solve this kind of problem?

If this is a new television then it is almost certainly a problem with the signal. If an alternative signal doesn't fix the issue then it's time to get in touch with Samsung who will no doubt offer to repair of replace the model.


Is there problem of multiple access interference and intersymbol interference problem in gsm?

MAI cause a significant problem when the power level of the desired signal is higher than that of the interfering signal. Multiuser detection(MUD) uses the information present in the MAI to decode the signal.


What can you use a signal generator to find?

To trace a problem in an amplifier. Send in a signal and trace its' path.


Turn signals dont work but hazards do Why Its a 1983 Civic with only 57000 miles. Yes only 57K. So does anyone know why such a low mileage vehicle would have this problem?

Probably a bad turn signal flasher - common problem


How can you check for a cable TV signal from a wall jack without a TV?

You can use a netbook computer with a USB TV tuner hooked up.


What is the next step when after the converter box is hooked up to rabbit ears for DTV conversion and the screen says weak signal?

Get a better antenae.


If the turn signal flasher on my instrument panel doesn't flash but the turn signal does what could be the problem?

Burnt out bulb.