I have a 98 Suburban with the 5.7 vortec V8. The cam sensor is in the distributor. Remove the cap and rotor to get to the sensor. Hope this helps.
I have the check engine light on and the code is for map sensor on my 1999 1500 Chevy suburban
The 1999 Chevrolet Suburban speed sensor is located on the back of the transmission. The speed sensor will be in the upper left-hand corner.
The 1999 Chevy Suburban camshaft sensor is located on the front of the engine. The camshaft sensor will be behind the front engine cover.
where is the speed sensor located on the 2004 Chevrolet suburban 4 wheel drive z71
The sensor is about $75.00 to $100.00 and the labor is 1/2 hour with 1 hour diagnostics. It is best to have the diagnostics done as you may not have a bad oxygen sensor. It could be as simple as a vacuum leak.
It does not have a crank shaft sensor.
NO. A crank sensor are cam sensor was not introduced until the year 1996.
The 2001 Chevrolet Suburban is equipped with one knock sensor. The knock sensor will be attached to the back of the engine.
No it does not. It has a distributor no need for a cam sensor.
A crank sensor was not USED on a 1995 model.
They were not used in 1986
It does not have one. It still has a distributor
Under the intake
Generally, the onboard diagnostics will tell you when you scan the computer codes.
Remove starter and sensor will be just above it.
Yes it will leak out of the hole that the sensor is screewed into.
No it does not. That engine still has a distributor.
The sensor is about $75.00 to $100.00 and the labor is 1/2 hour with 1 hour diagnostics.
The MAP (Manifold Absolute Pressure) Sensor on a 2000 Chevy Suburban is located on the very top of the motor. It is all the way to the back of the motor. There is nothing behind it.
www.autozone.com has a component locator that you can use. Fill in the information about your vehicle, go to the component locator and click on Oxygen Sensor. I have a 1997 Suburban and it identified the location of each of 4 sensors.
The headlight sensor on the dash of a 2004 Suburban is mounted to the left side of the steering wheel on the dashboard. To replace it, plug the wiring harness into the new headlight switch.
Iat / Idle air temperature sensor was not used on that year.
Through the use of a scan tool, service manuals, and proper diagnostics.
It can, but you should trust the computer diagnostics in a situation like that.