it is leakage in your cp150 120& 114 capacitors located on the flb circuit board should be green capacitors. with gold writing if bulged they are leaking if u can locate them heat them up with hair dryer for a couple minutes then power on t.v. usually works i did then just leave tv on u can buy these capacitors at tv repair world.com along with instructions for about $25.00
mine does the same thing, it used to work.
After much research, here is a step-by-step for getting your Vizio Soundbar to work with the Comcast remote using EFC codes (mine is the newer charcoal grey one, works great!) Aux - Setup (2 blinks) - 11144 (2 blinks) Aux - Setup (2 blinks) - 994 - Setup - 00169 - Vol Up - Should get 2 blinks Aux - Setup (2 blinks) - 994 - Setup - 00168 - Vol Down - Should get 2 blinks Aux - Setup (2 blinks) - 994 - Setup - 00037 - Mute - Should get 2 blinks Aux - Setup (2 blinks) - 994 - Setup - 00165 - Power - Should get 2 blinks Aux - Setup (2 blinks) - 994 - Setup - 00164 - Input - Should get 2 blinks These are optional, I didn't use them: Aux - Setup (2 blinks) - 994 - Setup - 00036 - <button to use for TVOL> - Should get 2 blinks Aux - Setup (2 blinks) - 994 - Setup - 00101 - <button to use for TSHD> - Should get 2 blinks Then set the volume control on the remote and other settings according to the Remote's manual. ENJOY!! Hope this helps someone...
If you want to add a remote, press the "set" button on the power unit until the green light blinks, then press the button on the remote. If you want the unit to forget all old codes and accept only the new remote, hold the "set" button until the green light stays on solid, then press the remote button.
It blinks if your DS is on and closed. It tells you that your power is on, but your not using it- Saving Energy/DS Power!
Couldn't find one for mine - the uverse remote just isn't that flexible. I bought a Logitech Harmony 650 remote for $70 on Amazon. Took a few minutes to setup, then it worked liked a charm instantly! Best $70 I ever spent.
The PS3's power indicator blinks when you turn off the system to tell you it's shutting off. As you probably know, the blue light indicates that a disc is in the drive and the red light is when the PS3 is off and in standby mode. A constant green blinking light could mean some problem occurred and it is taking longer than normal to shut off, if it doesn't turn off, hold the front power button down for 10 seconds to turn it off. You may then have to turn the PS3 on again with the same button as the PS button on the controller may not turn it back on.
if it says power button locked hold "<" button and power button till the message goes.(at least a min)
In most cases your HP notebook is in "power saving" mode. Please make sure your notebook is plugged into a power source as the battery could the result of the "blinking" ON button. If the battery is low, the computer will not turn on and will stay in "sleep" mode. If this is not the case, simply press and hold your power button that is blinking for 5-10 seconds. You will see your computer turn-off. Press the power button again (*given that the steps above have been followed through) and your computer light should turn back on and remain solid. If for some reason you find that the "ON" button light is constantly blinking, but the HP notebook is not turning on, make sure that your battery is not dead, and your power supply (the actual power cable and black power bar) is working.
Press, and hold the power button for 10 seconds to unlock the power button.
with the power button..... Press it
Your TV has a problem. If you watch the flashing red light and count the blinks, it's actually flashing a trouble code. Maybe something like four blinks, followed by three and then repeating. The other possibility is that it's in timer mode and the flashing light is reminding you that the timer's been set.
tHEN you can go to gamestop they fixed mine by just putting a pencil arounde it thus taking out the dust...