Your TV has a problem. If you watch the flashing red light and count the blinks, it's actually flashing a trouble code. Maybe something like four blinks, followed by three and then repeating. The other possibility is that it's in timer mode and the flashing light is reminding you that the timer's been set.
SONY
Use the set button just below the volume down key
Simply buy a RCA universal remote at your nearest dollar store and press the button that reads antenna. I had this same problem for weeks and i bought the remote today and tried everything for hours. Then my brother simply walks in grabs the remote presses the button and leaves. IT WORKS NOW.
You should not have to program this remote.... although it says universal on it. This is an original remote and should work when you put the batteries in. For T.V viewing, just push the t.v button on the top of the remote then power/on-off .... wait for the light, then the sound, then begin with your normal activities.
Press the Stop button on the remote control and at the same time press the Stop button on the DVD player itself for 10 seconds.
If the horn is honking and the lights are flashing just push the panic button on the remote to stop it
hold power button on wii remote and the wii goes in to stanby not off
citizen codes 001, 004, 008, 009, 042, 053, 058, 105, 109, 177If none of those work, you can also let the remote scan for the right code by turning on your device, pressing and holding the code search button until the red led illuminates, then release and press the button for your device (tv button), and then the power button... the remote will scan through its internal codes, flashing the red led through each code. When it gets the right code your device will shut off. Immediately press your "enter" button on the remote and that code will be stored in memory.
There is no reset button. The alarm is disarmed by using the remote or turning the key in the door lock.
Turn on the remote device and hold down the mode button until it starts flashing. Turn on the TV and scan through the device codes slowly. The correct one will flash eight times. The hit the pound key to store the code in the remote.
turn the wii on (everybody forgets this part)open the back of the wii remoteopen the slot on the front of the wii that has an SD card slot and a red button in itpress the sync button on the wii remote and the red button on the console within 5 seconds of each other (to allow for a reasonable amount of error)wait for the blue lights on the wii remote to stop flashing and the far left one to solidifythe remote and console are now synced. you may need to press a to get it to respond straight away.
If it is flashing when the truck is locked from the outside with the remote then it is because the alarm is activated (which happens when you press the lock button twice in most vehicles). Othewise there may be some other issue that you should have checked out by a Chevy dealer.
No. The factory alarm is reset with the remote or by turning the key in the door locks.
Look very closely at your REMOTE, I once found a button stuck down on the remote for an odd acting TV set. Push each button down a few times to see if any is stuck, It is possible you can't even see the problem button.
If your television has an IF "eye," it may be powered on using a remote control. Sorry your screwed.
Press the Power button. Some laptops have a remote and infrared box, so you can turn it on that way, too. Make sure your laptop is charged and the battery is secure if it's not turning on with the power button.
Its the same as honda civics. It a series of turning the ignition key off and on while pushing button on the remote. Im sure you can look that up as it's more common