answersLogoWhite

0


Best Answer

The 71 VW bug had an electric idle solenoid on the side of the carburetor which picked up its current from the + side of the ignition coil. First check that the wire is good and that it has 12 volts of current. Next you can touch the end of the wire to the post on the idle solenoid and listen for a click. If there is no click replace the solenoid. IF it clicks then the port may be stopped up in carburetor . You can gently use a air hose and blow out the port or disassemble the carburetor and do a complete overhaul. If the problem persist after these repairs put in a new electric idle solenoid. You also need to check the spray jet in the throat of the carburetor to insure it is clean and not stopped up.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Your 71 vw bug starts bug doesnt stay idle and stalls why is that?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you fix your 1990 Nissan 300zx when it doesnt stay idle and dies?

check your idle control valve located behind the engine


Your car stalls out when it first starts?

bad fuel pump, you dont have enough pressure to stay alive.


Why does your 89 Chevrolet idels in park but stalls when driven?

because it is not warmed up enough to stay running or you have the idle speed down too low and it not running at the right rpm to get the transmission up to speed


1992 buick lesaber doesnt stay running unless the gas pedal is pushed in no idle time how is this adjusted?

you will have to replace the trottle possitioning sensor (TPS) THIS WILL SOLVE YOU PROBLEM


Why would a 1992 Ford Explorer start fine but at idle the rpms go up and down until the car stalls?

Idle control solonoid. the vacuum line has probably blown a hose. most likely just needs to be re-connected. try a small nylon zip-tie if it wont stay by itself.


Why wont your 94 Chevy lumina stay running in idle try to give it gas and it stalls it runs for a few then dies Ive replaced the fule filter but it still sputters and dies like a sensor is bad?

You have to change the mass flow sensor


Briggs and stratton outboard motor owners manual?

won't stay running starts and goes then stalls Sounds like might be a float ,fuel filter or maybe just needs a good cleaning. Hope this helps.


Your 92 dodge Dakota stalls randomly while driving?

my 1992 dodge dakota wont stay running it stalls when driving and takes a few minutes to get started but if i wait it will start


How long can a corn on your foot stay?

it doesnt stay very long


1991 dodge ton pickup 360ci engine throttle body fuel injection cold starts multiple starts to stay running but idle surges fast slow as engine heats up idle gets somewhat better?

Check for a vacuum leak somewhere. It might just be a cracked rubber vacuum line. Try short sprays of starting fluid at or near a suspected vacuum leak. You'll hear the engine idle speed change immediately if you find a leak.


What do you do when after dating for 3 years and your boyfriend still does not stay at your house when your kids are home and they want him to stay they always ask him?

you tell him that if he wants to be with his kids he'll stay with you . but if he doesnt then he doesnt love you


My 4 runner starts but wont stay running.?

If once it stalls can you restart it? If not then see if the gas is missing or the spark has stopped. If you can restart it immediately then check the fuel pressures. Could be a low pressure from the puel pump or a clogged filter. As you run the car it cant feed enought to keep it going. But when starting the system has already built to pressure and filled the manifold. If this doesnt help try repeating the question with some points filled in. Thanks Jonathon