To be sure you need to tested on a DYNO.
The throttle body spacer is a small piece of metal that is attached the back of a throttle body. It is suppose to change the airflow which can potentially give you more horsepower and better fuel economy.
A throttle body spacer can save fuel as well as improve performance. This is done by adjusting the flow of air and fuel as it enters the intake.
there is a ton of stuff to do, computer chip, cold air intake, exhaust, or a new camshaft, bore the engine bigger, intake manifold, throttle body spacer, tons of stuff......
It improvea the horsepower, torque and the fuel economy of a car.
you can add a throttle body spacer, add a msd kit and platinum spark plugs and wires, cold air intake, you could gain about 15-20 more hp.
Poweraid
= Ford Throttle Body Spacer Description = In order for the engine of a Ford to run well, it needs a high volume of dense air coming into the combustion chamber at all times. Increasing the amount of air coming in to the engine will give the engine a power boost, and the Ford throttle body spacer is just the part to do the job. When installed, it will sit between the throttle body and the cold air intake. As the air comes into the Ford throttle body spacer, it is accelerated by a set of ridges that induces a vortex pattern into the flow. This allows the cold sir intake to move air in quicker. The Ford throttle body spacer also compresses the air, so that a larger amount will fit into the combustion chamber. The engine's computer will then increase the amount of fuel injected into the mixture, and when the combination is ignited, the resulting explosion will push the pistons down with more force. With the Ford throttle body spacer installed, the vehicle will gain several horsepower, and it will also see an increase in gas mileage. Because the hardware and gaskets that are required to install the Ford throttle body spacer are included in the kit, all that will be needed is a few simple tools. After the cold air intake is disconnected from the throttle body, and the gasket removed, the Ford throttle body spacer and gaskets can be installed. We carry the Ford throttle body spacer for many models in our online catalog, and with an easy, toll-free phone call or through our secure web site, the unit can be easily ordered. http://www.car-stuff.com/fordthrottlebodyspacer.htm
about 255 to 260 horsepower stock i have a cold air and a throttle body spacer plus magnaflow exhaust and headers and i am making around 300 horse
190 Horsepower which is stock for this engine. The K&N filter will add almost no horsepower at normal driving rpms. It will help some but only at higher rpms, which is a range that you will not be driving in. These type free flow filters only help in a racing environment, and do almost nothing for day to day normal driving. As to the TB Spacer, it does nothing to increase horsepower. I know you have more than likely been told that they add horsepower, but the dynos do not lie, and they simply do almost nothing for a no-race vehicle.
Yes, you can. TBI stands for Throttle Body Injection, and a spacer can be used provided you have the clearance for it.
bolted to the back of the throttle body spacer (elbow shaped thingy on top of the intake.)
i bought an Air Raid intake system and throttle body spacer. it cost just over $300, and it feels like i have a new jeep. it was very easy to install, took me less than an hour. i have 33 inch tires, and my 4.0 had a hard time keeping up in fifth gear before the install. now my power is better throughout the rpms. generally, any time you decrease the airflows resistance from intake to exhaust, horsepower, gas mileage, and throttle response is increased.