thats funny..i've done that too, but on a VW ok, peel back the other side, and if the wires are mathcing colors, it should be simple... otherwise, got any friends with an eclipse? lastly, and most intensive is a manual with a wiring diagram, call a library, and see if they have a Professional Shop manul available for your Bonzai Supernova...:) good luck
AnswerThe sensor is located in the distributor on the rear of the engine. The distributor has to be pulled to be able to remove the sensor.
i believe it is under the alternator
Where is the knock sensor located on a 1999 Subaru Forester?
Where is the outside temp sensor on a subaru forester 2007
When a Subaru has a faulty O2 sensor the fuel management is out of whack.
The physical position of the sensor is behind the water pump pulley, where you can see the the cable connection on the cover of the crankshaft and camshaft gears.
you cant there is an electronic throttle position sensor that controls idle may be bad
Throttle position sensor on this vehicle is held on by two screws. It's a 10 minute job.
Where is the bank2 sensor 1 located on a 2001 subaru outback 3.0
that the knock sensor does
If somebody knocks on the front door of the Subaru, the KNOCK sensor, sets off the KNOCK Alarm....LOL
A MAF sensor for a Subaru Impreza can cost anywhere from $70 - $150 depending on the type of Impreza you have.
where is crankshaft position sensor and camshaft position sensor on a 2004 Jetta 2.0 gl
No, the throttle position sensor detects how far open the intake is. The crank position sensor watches the rotation of the crankshaft.
CMP-camshaft position sensor CKP-crankshaft position sensor
The 1993 Subaru Legacy 2.2 liter engine ignition timing is the sequence that allows the engine to run smoothly. The ignition timing is synchronized with the crankshaft position sensor.
On the bottom of the throttle body - look where the pedal cable meets with the throttle body - look opposite the end of the connection assembly on the other side you will see the throttle position sensor.
The Code 45 you get in Subaru is as a result of the sensor which will cause the fuel cut.
The code 32 for a Subaru vehicle is for the coolant sensor or the oxygen circuit.
I mean a Trans position sensor I mean a Trans position sensor
No map sensor is manifold absolute pressure sensor and tps throttle position sensor
You cannot bypass this sensor.
Knock sensor/vibration sensor
I am led to believe that the camshaft position sensor is located at the front right side of the bay...underneath the oil refil cap...to the left of the battery...it has a small grey electrical plug attched with what should be a 10mm bolt. Hope this helps...
The intake air temperature sensor on a 2005 Subaru WRX is part of the mass air flow sensor. It is located in the air intake duct.