Yeah that is most likely the problem. When you change the starter, have someone rotate the dampner pully with a socket/ratchet and look carefully at the flywheel for any teeth missing. If teeth are broken off you will chew up more starters and cause more damage to the flywheel. Also make sure all the pieces of the broken starter are out of the space it occupies and there are no peces sitting in the bell housing. If they were to bounce up while in motion it could cause damage.
"You broke up with your boyfriend and he said that he doesnt really care are he cheat on you?
Sounds like maybe the timing belt/timing chain broke or jumped. If it will not run at all, I'd guess broke.
its broke
actually I broke the hood release latch on my 1991 Plymouth voyager, and I can't get the hood open, what can I do?
A broken starter housing is typically caused by either improper installation or manufacturing defect.
It means someone is crying quietly and in a distressed manner. The "broke sounds" could indicate a sense of emotional pain or desperation in the crying person.
because it's broke
he sounds desperate.
Yes, by a shop that rebuilds starters.
Check to make sure shift cable is adjusted properly. Also, check neutral start and back-up light switch located at the lower front edge of the transaxle. The center terminal of the switch grounds the starter solenoid circuit when the transaxle is in Park or Neutral allowing starter to engage.
something broke
I had the same problem on my 99 and a buddy on his 97.The positive wire harness(the one that hooks to the battery,starter,starter relay,etc) Has a break in it some where.Ours was broke or nearly broke on the starter solenoid.The crimped lug was broken.Sometimes it would start and other times it wouldn't.Check it, It may be the reason. I had the same problem on my 99 and a buddy on his 97.The positive wire harness(the one that hooks to the battery,starter,starter relay,etc) Has a break in it some where.Ours was broke or nearly broke on the starter solenoid.The crimped lug was broken.Sometimes it would start and other times it wouldn't.Check it, It may be the reason.