You need to check compression on #6.
See related link.
Fuel injector cleaner does not hurt anything,but most fuels already have a cleaning additive in their fuel.
yes you can. When I purchased mine from the original owner he had already replaced the middle bench seat with bucket seats.
The height of a cylinder all depends on what cylinder you are talking about. There is only an exact height if you have measured it yourself or someone has already measured it for you.
If the gas is compressed into the cylinder, yes. However if the gas is already pre-compressed (to the point of liquefaction) and simply decanted into the cylinder, there will be little to no heating of the receptacle cylinder.
I told you already, man. Use some C4 or other plastic explosive and attach it underneath, then get to a safe distance and detonate it. You don't think that that'll make it come out?
P0202 is injector number 2 circuit open. P2074 is map sensor TPS correlation. P0108 is map sensor circuit high. With all three codes I would think the wiring harness has been pinched or damaged near the rear valve cover, driver side.
Assuming the plugs and wires have already been replaced you may have a bad fuel injector.
PO300P0300 Random/Multiple Cylinder Misfire Detected. Can be a fuel injector problem. Install a can of Seafoam or Techron FI cleaner in a full tank of fuel. You may need to do it twice. Don't buy the cheap FI cleaners as they are worthless.Pontiac 1997 grand prix gtpyes
This question answered already
If it is already a gas, it does not need to evaporate.
Australia is already a country but a city in Australia is Sydney.