answersLogoWhite

0

The answer is some flat edge on a couple of needle bearings on the universal joint.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Clicking noise when accelerating?

A clicking noise, when accelerating, can be caused by a worn CV joint. The CV joint can cause the axle to collapse when it breaks.


Clicking or ticking sound when accelerating on your 83 Buick Regal?

Exhaust manifold gasket leaking


What causes a clicking noise when accelerating in a maxima?

Coming from the drive wheels? Could be worn CV joints


Clicking noise on my 1997 Chevrolet k1500 z 71?

cv axels if it does it when you are turning


What is the clicking noise under the driver's side dash on a 2003 Chevy Silverado?

could be the water pump. maybe radiator


What part makes a clicking noise next to the Blower Motor in a 1998 Chevy Silverado?

it is the blend door in the duct system


Defective outer cv joints usully make a clicking noise?

Yep, especially when accelerating from a stop and during low speed cornering. FriPilot


2003 Chevrolet suburban 280 hp engine making clicking sounds?

My 2003 Chevrolet Suburban 280 hp engine is making metal clicking sounds when I accelerate. It gets worse the faster I go. The battery went dead and had to be jumped two days ago. The car starts fine but then it makes this clicking sound when I put it in drive and go. It happens in park also. What is this?


Why does your car make a loud clicking noise while in motion but not accelerating?

Clicking sounds coming from the vehicle may indicate there are loose valves. Aside from getting a mechanic checkup, adding high mileage motor oil can also be helpful.


What would cause a 1987 Chevrolet Blazer s10 to stall out and make a loud clicking sound?

thae catalitic converter is pluuged


Why does your 2000 Silverado with 55000 miles make a clicking noise when in reverse?

most of the time when a u-joint starts going out it will make noise in rewind first


Your dodge Dakota is making a clicking noise only when accelerating What is it?

Its usually a U joint. Click under acceleration . While turning,a CV joint. Grinding or moaning is usually a bearing.