Oh, dude, aligning the headlights on a Ford Windstar is like trying to find your keys in the dark - frustrating but doable. You'll need a screwdriver and a flat surface to park on. Just locate the adjustment screws near the headlights, turn them until the lights are pointing where you want them, and voilà, you're good to go!
there is no adjustments on the headlights.
Specify what you mean.
On models 1996 onwards (this might also apply to earlier models), there are vertical and horizontal alignment screws on the front part of the engine compartment. The position of these alignment screws, and the associated water level indicators that you can use to align the headlights are illustrated in the Nissan Altima Owner's Manual, which can be downloaded for free from Nissan's website at: http://www.nissan-techinfo.com/nissan/deptog.asp?dept%5Fid=40
uses a bubble level to aim the headlights.
You do the smart thing and drive your 2004 Ford Focus to WalMart (not your Ford dealer...your Ford dealer will charge you $35.00 a headlight), and you let WalMart Tire and Lube men adjust your headlights for $5.00. You're done. Simple as that. For those who want to waste time but save a buck, aim your headlights at a wall from 25 feet away, find the adjusting screws near each headlight, and turn each screw until you achieve what you're looking for. The beams should be no more than 2.1" higher or lower than your headlights are from the ground.
There is only one adjuster on each lite. I do not remember the size of the socket drive, but if you remove the top panel under the hood on top of the head lites, you will see the adjuster.
Take it to the dealer and let them put there gauges on them to get them set right.
There are little black rods sticking up by the head lights that have a spot to put a screwdriver in. You turn these rods to aim the headlights correctly.
Park your vehicle approximately 15 feet from your garage door or another wall. Open the hood and on top of both of the headlights you will see adjustment screws. Rotating them will lower/raise the headlights
The are adjustment screws next to the headlight housings. To adjust the headlights either loosen or tight the screws. This will either raise or lower the headlight unit.
Take it to a dealer or a good body shop. You do not have the proper equipment to do this correctly.
You need special equipment to do this correctly. Take it to a dealer for this.