The expansion valve is located in the HVAC box inside the car. To gain access 1) Remove upper kick panels on both sides. 2) Remove dash trim that goes around the radio, HVAC controls and instrument cluster. 3) Remove rear vent duct from the heater box. (2 screws) 4) Remove harness connector from right side of heater box. (2 screws) 5) From under the car, remove the 90 degree rubber elbow from the firewall just below where the heater hoses go through. 6) Remove the lower cover from the heater box. (3 screws on each side, 2 near the firewall) 7) The heater core assembly will drop down giving access to the expansion valve.
how to change a valve cover gasket on a 97 mercury grand marquis ?
To change the expansion valve on a 1997 Pontiac Grand Am, first, ensure the AC system is fully discharged to avoid refrigerant exposure. Remove the dashboard or access panel to reach the expansion valve, typically located near the evaporator core. Disconnect the refrigerant lines and electrical connections from the old valve, then install the new valve in reverse order, ensuring all seals are secure. Finally, recharge the AC system and check for proper operation.
how to change fuel filter on a97 grand am
Doesn't have one.
To change the AC expansion valve on a 1997 Toyota T100, first, disconnect the battery and relieve the refrigerant pressure from the AC system. Remove the necessary components to access the expansion valve, typically located near the evaporator. Disconnect the refrigerant lines and electrical connectors from the old valve, then install the new valve, ensuring all connections are secure. Finally, reassemble the components, recharge the AC system with refrigerant, and test for proper operation.
The 2002 Grand Vitara EGR valve is located on top of the engine. The EGR valve will be between the engine and the battery.
Replace it.
The expansion valve is located on the passenger side of the vehicle behind the dashboard. To gain access to it you will have to remove the glove box and the dash.
Doesn't have one, that is a Ford/Mercury thing.
To change the transmission modulator valve in a 97 Pontiac Bonneville you will first need to lift the vehicle off the ground. Then, remove the vacuum hose and the defective valve. You can then replace with new, and replace the hose.
How to change a heater core on a 1997 Pontiac grand am
take off your valve covers and peel off the gasket you may have to scrape it off with a screwdriver but it wont hurt anything