I'm assuming that the Ford Escape and Mazda Tribute will be basically the same process since the vehiciles as practically the same. Hope this helps. Project: Replace dashlight behind odometer (PRNDL) light. 2001 Ford Escape.
Time: 10 to 30 min.
Tools: Nut Driver 7mm or (small 7mm socket, socket wrench and small extension)
Cost: $1.50 to $4.00 (cost varies due to location - or so I was told, mine was $4.00)
Screws to remove: only 6 on the 2001, all the same headsize, threadsize and length)
1. Remove two 7mm hex screws on display panel cover (top, underneith)
2. Put on parking brake, engage key (do not start), move PRNDL lever to L to get out of way.
3. Pull the bottom part of display cover straight toward you (there are 2 clips, one on either side of the steering wheel behind the display assembly cover that will snap free - takes a little force - Do one side at a time) Remove and set aside. This reveals the four display unit screws.
4. Remove the four 7mm screws on the actual display panel. (fyi: all screws in this project are the same headsize, threadsize, and length)
4. Tilt top of display panel toward you and remove the three top connectors (they come out easily and are in a cable harness so you can't put them back wrong) You will need to squeeze the middle gently, unlocking connector and pull)
5. Pull out display - which includes "glass" covering - this never gets removed! (adjust steering wheel to lowest position if needed)
6. On the rear of the panel you will see several (little grey) knobs. Find the one right behind the odometer and using a pliers, twist counter clockwise 1/4 turn and remove. The little light bulb is encased in these little knobs and is included as a one-piece replacement for the $1.50 to $4 bucks.
7. Replace bulb assembly by inserting the bulb and turning clockwise 1/4 turn.
8. Assemble following reverse instruction of above.
* This all sounds a lot more complex than it actually is. These steps each only take a minute or so. The most difficult part for me was pulling out the display assembly cover. Took me a few minutes to figure out that there were clips on either side of the base of the display cover and what pressure was needed to pull them free. (it does take a little effort at the base of the display to pull free)
All in all this took me about 15 minutes to remove and about 10 minutes to replace, but I had to find socket size, snap locations of cover, etc etc....
Please feel free to cut and paste this article to any other boards with the same question. I hate to see people getting "ripped off" for a simple 4 dollar job anyone can do.
The odometer light fuse also controls other lights on your instrument panel. The odometer light can be removed by removing the instrument panel cover. Push the light bulb in and turn at the same time. The light bulb will come out. Replace it with a new light bulb.
The brightness of the odometer lights on a 2003 Buick Century is controlled by the instrument panel dimmer switch. This switch allows the driver to adjust the brightness of the dashboard lights, including the odometer, based on ambient light conditions. Additionally, the vehicle's headlight switch may also influence the brightness of the instrument panel lights when the headlights are activated.
Typically, there is no specific fuse solely for the odometer light. Instead, the odometer light is usually part of the instrument cluster, which is powered by a fuse that controls multiple dashboard lights. If the odometer light is not functioning, it may be due to a blown fuse affecting the entire cluster or a malfunction in the instrument panel itself. Checking the vehicle’s owner manual can provide guidance on the relevant fuses.
The brake lights are accessed through the rear hatch. Find the panel on the rear sides of the car. Pop out the panel and access the brake lights. Replace the bulbs.
you open the truck or hatch and there should be a panel that comes off and u take it off and twist the light out change the bulb and place the light back in and put the panel back on the panel should be located on the inside of where the brake light is at
open your trunk to get access to your tail light, unscrew some plastic snap-on-screws to get to the panel that holds all your tail lights move the fabric uncling the panel CAREFULLY and change your burn bulbs
Panel lights on all vehicles are tied into the tail light wiring of the vehicle. That way if your panel lights go out you know that both tail lights are out. Check the bulbs of your cars tail lights and see if they are burned out.
remove interior panel and unscrew large black plastic nuts, remove light assembly
You probably don't need to change the dash lights. On the headlight panel there is a control to dim or brighten the dash lights. This same control allows you to turn them completely off. I don't remeber on that particular car if the light switch rotates or has a separate switch but all cars have this feature.
They can't be fixed. You have to change the radio. The climate control is the same way, You have to change the unit to get the light working.
There is no light bulb in that can be changed, you have to change the entire panel. Only the agents carry the panel.
remove plastic around instrument panel . remove screws from instrument panel then pull panel towards you to unplug it this will allow to get to dach lights