To check the coil pack on a 2000 Softail Deuce, first ensure the motorcycle is off and disconnected from the battery. Inspect the coil pack for any visible signs of damage, such as cracks or corrosion. Use a multimeter to measure the resistance across the primary and secondary terminals according to the specifications in the service manual. If the readings are outside the recommended range, the coil pack may need to be replaced.
To check the coil resistance on your 2001 Harley Deuce 1450 FXSTDI, first, ensure the ignition is off and disconnect the coil wires. Use a multimeter set to the ohms setting and measure the resistance between the positive and negative terminals of the coil. Additionally, check the resistance between the terminal and the plug wires; you should find values that fall within the manufacturer's specifications listed in the service manual. If the readings are outside the recommended range, consider replacing the coil or plug wires.
auto zone will check your codes for FREE. if you have a bad coil pack they will tell you.
To hook up a tachometer to a 2000 Harley Softail, first locate the ignition coil and find the negative terminal, which is usually marked with a "-" sign. Connect the tachometer's signal wire to this terminal. Then, connect the power and ground wires of the tachometer to a suitable power source and ground on the bike. Finally, ensure all connections are secure and test the tachometer by starting the bike.
You will have to have it scanned for codes, check with your parts house. They may scan for you.
check your coil pack - mine had the same issue before.
How do I get to the bottom bolt on the coil pack of my 2000 Camry
Well, there's a lot to check, but it sounds electrical- Check wires, plugs- I had a bad coil on my 2000. Open up the cowl to see if there is any arcing of the coil, wires etc. While you have it open, check the cap and rotor Astroman
Have AutoZone check for codes (FREE). It may be a bad coil pack...
Auto Zone will check your computer codes for FREE.. It maybe a Bad Coil Pack.
Probably the number two ignition coil. Also check the spark plug and the wiring to the coil.
The 2000 Blazer with the 4.3 engine has one coil.
use an multimeter to check the resistance between 1-4 and 2-3 on the coil pack, u should get around the same figures.