Remove the rectangular plastic insert from the inside of the hatch door. It is directly opposite of the license plate lights. It is not easy to do. Use a thin screwdriver or other similar tool to wedge between the insert and the rest of the door. It will snap out with a little effort.
Remove the wire from the light by squeezing the tab on the connector and pulling out the connector.
Once done you will either need small hands or a needlenose pliers. Twist the plastic light holder counter-clockwise about 1/4 turn and it should pop out.
how do you replace license pate light on 2006 pontia g6
Remove the two 10 millimeter screws and pull the housing down and replace the bulb
The license plate light bulb on a 2002 Pontiac Grand Prix is replaced by removing the retaining bolts and pulling the bulb out of its socket. A new bulb is then put into the socket and reassembled.
how to replace map light bulb in a 2006 pontiac torrent
you can see the plugs on the back of the light. lift the trunk and look past the license plate . the twist out . righty tighty lefty lousy . pull them out. its tight but they come out. use needle nose pliars, but be gentle.
It is a Pontiac Aztek. Light a match and get some marshmallows.
On a 1998 Pontiac Sunfire, the tag light is located above the rear license plate. It is typically housed within the rear trunk lid or panel, illuminating the license plate for visibility at night. To access the bulb for replacement, you may need to remove any covering or panel that shields it.
Ive been trying to figure this out myself,there's no bulb on mine.An no apparent access to it from outside or the trunk
To replace the brake light on a 2000 Pontiac Montana open the trunk to reveal the housing units. Find the lights and pull the bulbs out. Replace the units.
IT is in the sun
Unscrew license plate and remove to expose light fixtures. Wedge light module away from holes. Replace them and return them to sockets.
I'm guessing that you're referring to the lamps that light up the PONTIAC name across the center of the trunk lid. You access those lamps from the inside of the trunk lid IE: the back of the PONTIAC name. Mine were pretty stuck in place, so I ended up removing that entire rear light assembly. It comes out with about 6 screws. That gives you more access to the connectors.