Connect the green wire to the negative side of the coil.
on the drivers side of the distibutor cap using a blade electrical hook up you can plug into the opening or if there is a wire already there splice into it make sure all your grounds are in place or you will burn up you coil
On the distributor cap there is an extension that juts out toward the driver side. underneath this are two wire terminals. they should be marked on the top of the cap "Tach" and "Batt." A wire with a male spade end crimped onto it fits into the "tach" terminal and provides a signal for your tachometer to use.
if it is a hei ignition there is a place on the distributor cap that says tach.
NO.
where does the hot wire come from going to the distributor on a chevy 350
The distributor should face forward rather than backward on the Chevy 350. It is important to mark the front face of the distributor before removing it.
305 is the same distributor as a 350 will even fit some big block chevy's.
Yes. Its a direct bolt in.
The distributor and the oil filter.
no
inside the distributor.
yes