0
I just use the crankshaft bolt to squeeze it back on. Just line up the groove in the harmonic balancer to the key in the crankshaft and slip it on until it's snug. Screw in the crankshaft bolt and tighten it down. The more you tighten, the more it will push the harmonic balancer. Warning! The crankshaft bolt must screw in freely at least five or six turns before you can begin tightening it. If the bolt ain't long enough then you will have to find one the same size, but just a little longer or you could face an unholy nightmare if you strip the bolt out. Use the long one if you have to to get the balancer pushed on a bit. Then, switch back to the original bolt and finish tightening. Good Luck and Good Day!
What else can I help you with?
How do you install a crankshaft sensor on a 1992 Buick Century?
take off your harmonic balancer the answer is behind
What should the torque be when tightening a harmonic balancer on a 3.3 buick century?
About 200 foot pounds.
Why does your 91 Buick century idols high after replacing harmonic balancer?
sounds like you broke the crank sensor that is mounted right behind the balancer.
How do you put a harmonic balancer on a Buick Riviera Is there a certain way?
To install a harmonic balancer on a Buick Riviera, first ensure the engine is at TDC (Top Dead Center) on the compression stroke for the first cylinder. Align the keyway on the balancer with the key in the crankshaft, then slide the balancer onto the crankshaft. Use a harmonic balancer installation tool to press it on evenly and avoid damaging the crankshaft. Finally, torque the retaining bolt to the manufacturer's specified settings.
How do you replace harmonic balancer 1994 Buick Regal?
To replace the harmonic balancer on a 1994 Buick Regal, start by disconnecting the negative battery cable and removing any components obstructing access, such as the serpentine belt and crankshaft pulley. Use a harmonic balancer puller to carefully remove the old balancer from the crankshaft. Install the new harmonic balancer by aligning it properly and using a torque wrench to tighten it to the manufacturer's specifications. Finally, reassemble any components you removed and reconnect the battery.
How do you pull a Harmonic Balancer on a 1992 Buick Riviera.?
You need a harmonic balancer puller, and a 1/2 in drive inpact wrench.
Where is the crankshaft sensor on 2001 Buick Century?
its right behind the harmonic balancer....so you will have to remove the h.b them remove the crank sensor...
How do you change harmonic balancer on 1991 buick lesabre?
The flywheel has to be held in place by a holding tool, Remove the mounting bolt, then use a balancer remover to pull the harmonic balancer.
Does the intake manifold on a 1999 Buick Century have to be removed in order to replace the cam shaft position sensor?
no it;s behind the harmonic balancer take off passenger right front tire and you can get at it. you will need a wheel puller to pull the harmonic balancer off
Location of the crankshaft sensor on a 1998 Buick Century?
the crankshaft position sensor is located right behind the harmonic balancer mounted on the timing cover
Does a 1992 Buick Century have a harmonic balancer?
Yes, all cars do. It is the crankshaft pulley assembly...the biggest pulley, typically, at the very bottom of the engine.
How do you install a harmonic balancer on a 96 Buick Riviera super charge?
Just put the cam bolt back in and tighten it down, it will go back in easy
