Caution:On models with a Delco Loc 2 or Theftlock audio system be sure the lockout feature is turned off before proceeding * Disable the airbag system * Remove the tilt lever if equipped * Remove the upper and lower steering column covers Ignition Switch * Remove the ignition switch retaining screws * Detach the ignition switch from the steering column housing assembly and unplug the electrical connectors Key Lock Cylinder * Turn the key to the run postion * Depress the lock button and remove the key lock cylinder
how to remove key cylinder on 98 sunfire
yes
* Remove the front bumper fascia * Unplug the horn electrical connector and remove the bracket bolt
If you pick up a Haynes or Chilton manual for the car, it will show you how to remove and replace the ignition switch. You might be able to find out why it won't turn without having to replace it. Another option would be to call a locksmith.
You must first remove the trunk door facia. (This is the part with the "Pontiac" lights in it.) Then you can get to the bulb to replace it.
You can replace the ignition lock cylinder in your 1994 Pontiac Firebird without removing the steering will. Remove the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out.
To remove the tumbler and ignition switch from a 2002 Pontiac Sunfire, first, disconnect the negative battery cable to prevent electrical issues. Next, insert the key into the ignition and turn it to the "Run" position. Use a small screwdriver to press the release pin located on the ignition switch assembly and then pull out the tumbler. Finally, remove the ignition switch by unscrewing any retaining screws and disconnecting the wiring harness.
remove both hoses and replace the o rings
I need to know how to remove a rear wheel speed sensor on a 2002 Pontiac Sunfire
Remove the serpentine belt. Tensioner is below Alternator. Remove the three mounting bolts on the tensioner baracket assembly. Replace entire unit.
Remove the panel under steering wheel. There will be 2 flashers. Replace one on right.
To replace the dashboard lights in a 2005 Pontiac Sunfire, first, disconnect the negative battery cable for safety. Remove the dashboard trim panel by unscrewing any screws and gently prying it off. Then, locate the bulb sockets on the back of the gauge cluster, twist them counterclockwise to remove, and replace the burned-out bulbs with new ones. Finally, reassemble the dashboard and reconnect the battery.