The coil is located in the top part of the distbutor cap
To remove the ignition switch in a 1981 Corvette, insert the key into the ignition while leaving it in the "off" position. Insert a straightened paper clip next to the key, turn the key to the "Acc" position, pull the key and clip out together, and place the coil down.
Its right above the ignition coil. Infact you have to remove it first to remove the ignition coil.
Where all the wires plug into. That is the ignition coil. The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
2 screws.
The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
Yes, but you will need to remove any ballast resistor or resistance wire going from the ignition switch to the + side of the coil and replace it with copper.
REMOVAL PROCEDURE Remove the engine cover. Disconnect the spark plug wires at the ignition coils. Disconnect the ignition coil harness connector. Remove the ignition coil mounting bolts. Remove the ignition coil. INSTALLATION PROCEDURE Install the ignition coil to the bracket. Install the ignition coil mounting bolts. NOTE: Refer to Fastener Notice in Service Precautions. Tighten Tighten the ignition coil mounting bolts to 8 N.m (71 lb in) . Connect the ignition coil harness connector. Connect the spark plug wires at the ignition coils. Install the engine cover.
The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil
The ignition coil should be inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
On top of each spark plog. The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
if the coil is on the distributor cap,remove cover then disconnect wires from the coil and remove coil. if coil is on engine then loosen the bolt and remove from coil mount
The coil is supplied power by the ignition, remove the wire and it will not operate.