There are 8 socket (Allen) screws aroung the panel - 2 front, 2 back, 3 across the bottom - remove these. Then you have to pry off the cover of the grab handle. The cover only - look for the seam. Underneath, there are two large Phillips head screws - remove these. Pry off the speaker cover. There are 4 Phillips head screws there - remove them. Remove the wires from the speaker. The door panel will come straight off - not up. Be careful of the the wiring to the mirror control and the window control.
--Paul (pm remove this souza@Yahoo.com
No. To remove the widow its easiest to remove the outside panel
you take off the nuts and bolts
Remove the dppr panel and there are screws on the inside.
You have to remove the inside door panel then you can see the holding assembly
remove door panel, install new window
You have to remove the steering wheel and driver airbag to replace this multi function switch....trust me I had to do it.
The rear gate panel is very easy to remove. You will need a panel remover or a paint scrapper or something flat to pull panel off. Also you will need a screw driver to remove a few screws. Be careful not to break or lose any parts. Good luck...
Go to the following website. It will show how to remove the door panel and the side mirror. kwmuth.com
To remove the door panel of a 1997 Ford F-150 driver side, start by disconnecting the negative battery cable for safety. Remove any screws securing the panel, typically found near the door handle, armrest, and at the bottom of the panel. Carefully pry off the panel using a trim tool or flathead screwdriver, starting from the bottom and working your way up to avoid damaging clips. Once loose, disconnect any wiring harnesses for power windows or locks before fully removing the panel.
To right of ashtray and above the lighter there is a small removable panel aprox 2"x2"gently remove it from around the edges and it will come off to reveal the diagnostic plug port.
Door Panels Removal & Installation 1. Remove the sail panel. 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc. 4. The installation is the reverse of the removal.
i have a '96 cavalier and all u have to do is stick a screw driver in the panel beside the radio to where u can get your fingers in there and just pull it out. but be careful that u dont break the panel or the clips.