To remove the ignition module on a 1992 Oldsmobile 88 Royal, first, disconnect the negative battery cable to ensure safety. Next, locate the ignition module, which is typically mounted on the distributor. Remove the electrical connectors attached to the module and unbolt it from the distributor using a socket wrench. Finally, lift the module off the distributor base to complete the removal.
To remove the ignition switch from a 1990 Oldsmobile Delta 88 Royal, first disconnect the battery to avoid any electrical issues. Then, remove the steering column covers to access the ignition switch. Use a flathead screwdriver to release the retaining tab and turn the switch to the "off" position while pulling it out. Finally, disconnect the wiring harness from the back of the switch before removing it completely.
Its labled IGN
Oldsmobile never made a car named Royal Brougham
No
To remove the hubcap from a 1989 Oldsmobile 88 Royal, start by locating the small notch or slot on the edge of the hubcap. Use a flathead screwdriver or a similar tool to gently pry the hubcap away from the wheel, starting at the notch. Carefully work your way around the hubcap to detach it completely without damaging the wheel or hubcap. Once loose, simply lift it off the wheel.
whys smoke coming from oil pan in a 1994 oldsmobile royale
usually you don't. Use a socket wrench with an extra long handle or "breaker bar". Turn in the direction indicated on the tensioner, and the tensioner will move enough for you to remove the belt. Once the belt is off, you can remove the tensioner if you have to.
What is and where is the soft seal located?
Around 3400-3500 lbs
the thermostat is located where the top radiator hose attaches to the engine. there are three bolts that take off the water neck that the hose attaches to. remove those bolts, the thermostat is inside.
Hemmings Motor News.com
.060 thounsands