0
How do you remove the ignition switch from a 1997 Pontiac Sunfire SE with no tilt steering?
There is a recall on '97 sunfires ignition switches. My car wouldn't start and after trying it several times smoke started coming from the ignition column. they will install a relay switch w/ your ignition switch to convert high voltage away from it. If it doesn't start and you continually try it or hold it back too long it will start to burn as mine did A Pontiac dealership fixed it for free but I had to fight them on the towing costs. I would do a search on the recall or call a Pontiac/GM dealership and they can tell you if it goes towards yours... you!
Also check for other recalls such as the PCM recall.
What else can I help you with?
Can you replace the ignition lock cylinder on a 1994 Pontiac firebird without removing the steering wheel?
You can replace the ignition lock cylinder in your 1994 Pontiac Firebird without removing the steering will. Remove the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out.
How to replace ignition key cylinder for 1996 Pontiac sunfire and recheck theft deterent and code new key cylinder to vehicle?
how to remove key cylinder on 98 sunfire
Where is the valet overide button on a 2000 Pontiac sunfire?
The valet override button on a 2000 Pontiac Sunfire is typically located under the dashboard, near the steering column. It may be positioned above the brake pedal or near the ignition switch. You might need to remove a cover or panel to access it. Always refer to the owner's manual for specific details and diagrams.
How do you pull an ignition for 1984 Pontiac fiero 2m4?
Remove steering wheel Remove Steering lock plate Place ignition in on position Depress lock pin now exposed. If this is not possible, drill out lock pin.
Where is ignition switch located on 2000 Pontiac Montana?
On the 2000 Pontiac Montana, the ignition switch is located on the steering column, behind the steering wheel. To access it, you typically need to remove the lower steering column cover. This switch is connected to the ignition lock cylinder, allowing you to start the vehicle when the key is turned.
How do you remove ignition switch 1970 Pontiac gto?
To remove the ignition switch from a 1970 Pontiac GTO, first disconnect the battery to ensure safety. Then, remove the steering column cover by taking out the screws or bolts securing it. Locate the ignition switch, disconnect the wiring harness, and unscrew the switch from its mounting position. Finally, pull the switch out carefully from the steering column.
Where is the signal flasher located on the 1995 Pontiac Sunfire and how do you get to it to change it?
Remove the panel under steering wheel. There will be 2 flashers. Replace one on right.
How do you remove and replace an ignition in a 1997 Pontiac Sunfire?
Caution:On models with a Delco Loc 2 or Theftlock audio system be sure the lockout feature is turned off before proceeding * Disable the airbag system * Remove the tilt lever if equipped * Remove the upper and lower steering column covers Ignition Switch * Remove the ignition switch retaining screws * Detach the ignition switch from the steering column housing assembly and unplug the electrical connectors Key Lock Cylinder * Turn the key to the run postion * Depress the lock button and remove the key lock cylinder
How do you remove air bag coil on a 1997 Pontiac sunfire?
To remove the airbag coil (also known as the spiral cable) on a 1997 Pontiac Sunfire, first disconnect the negative battery cable to ensure safety. Then, remove the steering wheel by unscrewing the retaining nut and using a steering wheel puller if necessary. After that, detach the airbag module by unfastening the screws and disconnecting the wiring harness. Finally, you can access and remove the airbag coil from the steering column by carefully releasing any retaining clips and pulling it out.
How do you remove the tumbler's and ignition switch from a 2002 sunfire?
To remove the tumbler and ignition switch from a 2002 Pontiac Sunfire, first, disconnect the negative battery cable to prevent electrical issues. Next, insert the key into the ignition and turn it to the "Run" position. Use a small screwdriver to press the release pin located on the ignition switch assembly and then pull out the tumbler. Finally, remove the ignition switch by unscrewing any retaining screws and disconnecting the wiring harness.
How do you repair the ignition in a 97 Pontiac Sunfire?
Caution:On models with a Delco Loc 2 or Theftlock audio system be sure the lockout feature is turned off before proceeding * Disable the airbag system * Remove the tilt lever if equipped * Remove the upper and lower steering column covers Ignition Switch * Remove the ignition switch retaining screws * Detach the ignition switch from the steering column housing assembly and unplug the electrical connectors Key Lock Cylinder * Turn the key to the run postion * Depress the lock button and remove the key lock cylinder
How do you replace the ignition switch on a 1998 Pontiac Sunfire?
Caution:On models with a Delco Loc 2 or Theftlock audio system be sure the lockout feature is turned off before proceeding * Disable the airbag system * Remove the tilt lever if equipped * Remove the upper and lower steering column covers Ignition Switch * Remove the ignition switch retaining screws * Detach the ignition switch from the steering column housing assembly and unplug the electrical connectors Key Lock Cylinder * Turn the key to the run postion * Depress the lock button and remove the key lock cylinder
