theres a clip. unclip it. use a small screwdriver to push the clip out and pull it out.
Remove the windshield wiper arm from the windshield wiper motor. Remove the wiring harness. Remove the retaining nut. Reverse the process to install the new windshield wiper motor.
The heater vents above the stereo can be easily pried out. This should expose the mounting screws for the panel.
The fuse for the windshield washers on a 2000 Jeep Cherokee Sport is located in the fuse box under the dashboard on the driver's side. Specifically, it's typically the fuse labeled for the windshield washer or wiper system. To access it, remove the cover from the fuse box and check the diagram on the inside for the exact location. If the fuse is blown, replacing it should restore functionality to the windshield washers.
Where is the windshield wiper relay located on a 1996 grand jeep Cherokee
The 1994 Jeep Grand Cherokee takes 20" replacement windshield wiper blades on both sides front and a 10" or 11" wiper on the rear.
try compound
They are both located under the plastic wiper cowl in the area between the hood and windshield. Remove the wipers (if you aren't sure how to do that you pull the tabs about 3/4 of the way out) then you remove the screws in the wiper cowl. Once it is removed you should see both the wiper motor and control bar.
# Remove the windshield wiper arms # Remove the cowl cover # Disconnect the electrical connector from the wiper motor # Detach the wiper motor/linkage assembly from the cowl # Remove the wiper motor retaining bolts and remove the motor
* Remove the windshield wiper arms * Remove the cowl cover * Disconnect the electrical connectorr from the wiper motor * Detach the wiper motor/linkage assembly from the cowl * Remove the wiper motor retaining bolts and remove the motor
under grill between bonnet [hood] and windscreen you need to remove grill to get to it
ITS WITH THE WIPER MOTOR ITS ALL ONE UNIT
You have to remove the linkage from the wiper motor.