answersLogoWhite

0

look where the gear comes through the body, the arm has a small lock under the hollow part of the arm where it connects to the gear, release the lock and pull on the arm.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the wiper motor on a 1988 jeep wrangler located?

The 1988 Jeep windshield wiper motor is located on the firewall in the engine compartment. The wiper motor will be in the center of the firewall.


How do you remove the windshield wiper motor on a 1988 Firebird?

To remove the windshield wiper motor on a 1988 Firebird, start by disconnecting the negative battery cable to ensure safety. Next, remove the wiper arms by unscrewing the retaining nuts and pulling them off the splines. Then, access the motor by removing the interior panel or cowl cover, followed by disconnecting the electrical connector and unscrewing the motor from its mounting bracket. Finally, carefully pull the motor out of its housing.


How do you fix windshield wiper motor on a 1988 crx Honda?

To fix the windshield wiper motor on a 1988 Honda CRX, first ensure the problem is indeed the motor by checking the fuse and wiper switch. If those are functional, remove the wiper arms and the cowl panel to access the motor. Disconnect the wiring harness and remove the mounting bolts to take out the faulty motor. Replace it with a new or refurbished motor, reassemble the components, and test the wipers to ensure proper operation.


How do you replace windshield wiper motor on a 1988 Mercedes 560SL?

under sterring column remove the 2 covers you will see 3 nuts and linkage remove and pull motor out from engine bay


Does the 1988 Nissan Pulsar se have two separate front windshield wiper motors?

No


How do you change the wiper blades on a 1988 Chevrolet celebrity?

To change the wiper blades on a 1988 Chevrolet Celebrity, first lift the wiper arm away from the windshield. Press the release tab on the old wiper blade, then slide it off the arm. Align the new wiper blade with the arm, ensuring it locks into place, and gently lower the wiper arm back onto the windshield. Repeat the process for the other wiper blade if needed.


Where is the windshield wiper fuse on an 88 ls Oldsmobile?

The windshield wiper fuse on a 1988 Oldsmobile Cutlass Supreme LS is typically located in the under-dash fuse box. To access it, you'll need to remove the cover of the fuse panel, which is usually situated on the driver's side, near the steering column. Look for a fuse labeled "Wiper" or "Windshield Wipers" and check if it's blown. If so, replace it with a fuse of the same amperage.


What is wrong if the windshield wiper motor on a 1988 s10 sometimes makes noises but the wipers never work?

Broken or disconnected wiper transmission (linkage)?


Where is the windshield wiper pump located on a 1988 Chevy Nova?

look on the bottom of the washer fill tank.


How do i remove a Windshield washer pump on a Toyota 4-runner?

How do I remove a windshield washer pump from a toyota 4-runner 1988?


Toyota 4-runner 1988 after installing windshield wiper motor wipers stay up how do you get them to go down when you turn them off?

when u turn wipers off they stay at up position. while in up position remove wiper arms from vehicle then place wiper arms at down position and renistall on wiper motor shaft. that should fix the problem


Why would your windshield wipers stop working on your 1988 Mazda 323?

Your windshield wipers on a 1988 Mazda 323 may stop working due to several reasons, such as a blown fuse, a faulty wiper motor, or worn-out wiper blades. Additionally, issues with the wiper switch or a broken linkage could also be the culprit. Inspecting the fuse and testing the wiper motor can help identify the problem. If these components are functioning properly, it may be necessary to check the wiring for any damage.