look on the bottom of the washer fill tank.
The 1988 Jeep windshield wiper motor is located on the firewall in the engine compartment. The wiper motor will be in the center of the firewall.
the pump for the washers is contained in the reservior which is located on the right side of the engine compartment right by your coolant reservior. the sprayers themselves are just tubes that run up your windshield wiper arms.
To replace the wiper blades on a 1988 Chevy Corsica, first lift the wiper arms away from the windshield. Press the small tab on the wiper blade connector and slide the old blade off the arm. Align the new wiper blade with the connector and push it onto the arm until it clicks securely into place. Finally, lower the wiper arms back onto the windshield.
If you are standing at the front of the car, the module is located on the right side of the firewall by the windshield wiper motor....
No
To change the wiper blades on a 1988 Chevrolet Celebrity, first lift the wiper arm away from the windshield. Press the release tab on the old wiper blade, then slide it off the arm. Align the new wiper blade with the arm, ensuring it locks into place, and gently lower the wiper arm back onto the windshield. Repeat the process for the other wiper blade if needed.
Yes.
Broken or disconnected wiper transmission (linkage)?
The windshield wiper fuse on a 1988 Oldsmobile Cutlass Supreme LS is typically located in the under-dash fuse box. To access it, you'll need to remove the cover of the fuse panel, which is usually situated on the driver's side, near the steering column. Look for a fuse labeled "Wiper" or "Windshield Wipers" and check if it's blown. If so, replace it with a fuse of the same amperage.
To remove the windshield wiper motor from a 1988 Pontiac Firebird, first disconnect the negative battery cable to ensure safety. Then, remove the wiper arms by taking off the nuts securing them and carefully prying them off the motor spline. Next, access the motor by removing the interior panel under the windshield, and disconnect the electrical connector. Finally, unbolt the wiper motor from its mounting bracket and carefully pull it out.
NO. You need one from 1988 to 1999
Its mounted on the washer pump/wiper motor.