0
What else can I help you with?
1988 Pontiac Trans Am GTA Headlights Relay Location?
If you are standing at the front of the car, the module is located on the right side of the firewall by the windshield wiper motor....
Where is the wiper motor on a 1988 jeep wrangler located?
The 1988 Jeep windshield wiper motor is located on the firewall in the engine compartment. The wiper motor will be in the center of the firewall.
Does the 1988 Nissan Pulsar se have two separate front windshield wiper motors?
No
How do you change the wiper blades on a 1988 Chevrolet celebrity?
To change the wiper blades on a 1988 Chevrolet Celebrity, first lift the wiper arm away from the windshield. Press the release tab on the old wiper blade, then slide it off the arm. Align the new wiper blade with the arm, ensuring it locks into place, and gently lower the wiper arm back onto the windshield. Repeat the process for the other wiper blade if needed.
Where is the wiper motor control module on a F150 1988 ford?
On a 1988 Ford F-150, the wiper motor control module is typically located under the dashboard on the driver's side. It can often be found near the steering column or mounted to the firewall. Accessing it may require removing some panels or components for better visibility and reach. Always refer to a service manual for specific details related to your vehicle's configuration.
What is wrong if the windshield wiper motor on a 1988 s10 sometimes makes noises but the wipers never work?
Broken or disconnected wiper transmission (linkage)?
Where is the windshield wiper pump located on a 1988 Chevy Nova?
look on the bottom of the washer fill tank.
How do you change the ignition control module in a 1988 Chevy Silverado 5.7 L?
How do you change the ignition control module in a 1988 Chevy Silverado 5.7L
How do you remove the windshield wiper motor on a 1988 Pontiac Firebird?
To remove the windshield wiper motor from a 1988 Pontiac Firebird, first disconnect the negative battery cable to ensure safety. Then, remove the wiper arms by taking off the nuts securing them and carefully prying them off the motor spline. Next, access the motor by removing the interior panel under the windshield, and disconnect the electrical connector. Finally, unbolt the wiper motor from its mounting bracket and carefully pull it out.
How replace wiper blades on 88 Corsica?
To replace the wiper blades on a 1988 Chevy Corsica, first lift the wiper arms away from the windshield. Press the small tab on the wiper blade connector and slide the old blade off the arm. Align the new wiper blade with the connector and push it onto the arm until it clicks securely into place. Finally, lower the wiper arms back onto the windshield.
How do you remove the ignition module on a 1988 ford f-250?
how do you remove the ignition control module on a 1988 ford f-250 pickup?
Where can you get the guide for 1988 F 250 Electronic control Module?
it shows you steps about what you are suppose to do on a module guide.
