You dont repair it...you have to replace it.
In most cases the crank pulley bolts to the balancer so the crank pulley would not be the same as the harmonic balancer.
I would contact the local parts store and replace the harmonic balancer if you think it is bad. a bad balancer can cause failure in the crankshaft bearings because of the shake.
On the 2005 Chrysler Sebring, the condensate drain is located under the hood. It is on the firewall. Haynes makes a repair manual with diagrams and instructions on how to repair a condensate drain.
To remove the harmonic balancer from a 1993 Ford Tempo, first, disconnect the negative battery terminal and remove any belts attached to the balancer. Next, use a harmonic balancer puller tool to carefully extract the balancer from the crankshaft. Make sure to follow any specific torque specifications during reinstallation if you're replacing it. Always consult a repair manual for detailed instructions and safety precautions.
The oil leak is probably comming from the top of the oil pan there is a rubber gasket that goes between the oil pan and the water pumb which would make it look like its comming from the harmonic balancer, try replacing the oil pan gasket this should fix the problem. New answer: There is a small round oil seal / Harmonic balancer seal that fits in the timing cover and the balancer slides through the center of it. That is probley were your oil leak is. Most of the time the balancer itself gets a groove wore in it over time from that rubber seal running on it. You can repair the balancer by buying a Harmonic balancer repair sleeve/ speedy seal. Also replace the front timing cover seal.
70-90 LBS par Hanes repair manual
A stereo wiring diagram for a 1997 Chrysler Sebring can be found in its maintenance manual. It can also be found in its repair manual.
do not repair, replace it only ! For explicit instruction as to procedure, please refer to answer for 1999 ISUZU RODEO crankshaft in automotive section herein.
That will depend on the problem. Could be $100-$1000.
I live in Arizona. I just got a quote at my usual repair shop, because they spotted a wobble in mine. This shop wanted a total of $215, ($135 for the part, $80 for labor) -Greg
Replace the blown fuse, or repair the broken wire.
To fix messed up threads on a harmonic balancer, you can use a thread repair kit, such as a Helicoil, which allows you to insert a new threaded insert into the damaged area. First, drill out the damaged threads to the appropriate size, then tap the hole to accommodate the insert. Finally, screw in the Helicoil insert with the provided tool and ensure it's secure. If the damage is too severe, consider replacing the harmonic balancer entirely.