For a Galant:
Open the trunk. Remove the three clips. Take off the trim cover partially. Remove the three light case mounting nuts. Push the white square grommet and remove the light case. Remove the socket assembly and bulb together by turning it counterclockwise. Take off the bulb by turning it counterclockwise while pushing it inward. The outer two bulbs are for the tail light. Use bulb number 2057.
afshar13@yahoo.com
You can not, you will have to replace the entire tail light.
Take 2 screws out and pull light straight back, it will come over, replace bulbs and put back on and replace screws
Assuming it is the same as a '99 Galant: you go into the trunk and unscrew the three plastic caps that are holding the fabric-covered partition on on the side of the tail light that needs the new bulb. Then, undo the nuts holding the bolts on. There is a plastic-covered bolt there - push on that and it pushes the entire tail light assembly out. Then, undo the bulb holder and replace the bulb.
To replace the tail light on a 2007 Mitsubishi Endeavor, first, open the rear hatch and locate the access panel on the interior side of the tail light assembly. Remove the panel by unscrewing or unclipping it, then disconnect the electrical connector from the tail light bulb socket. Twist the bulb socket counterclockwise to remove it, replace the burnt-out bulb with a new one, and reassemble by reversing the steps. Finally, test the new bulb to ensure it is functioning properly before closing the access panel.
well its easy look up your bum ya monkey!
to replace the tail light open the hatch look on the side of the light you will see two screws remove them. Pull the light out, take the three bulb out ken
to replace tail light lens on a ford pickup. lower tailgate on side of bed that is hidden when tailgate is closed, you will see 2 screws. remove these screws and you can pull tail light out of bed.
To remove the tail light on a 2007 Mitsubishi Lancer, first, open the trunk and locate the access panel behind the tail light assembly. Remove the screws or clips securing the panel, then disconnect any wiring harnesses attached to the tail light. Unscrew the bolts holding the tail light assembly in place and gently pull the assembly out to remove it. Finally, replace the tail light as needed or reinstall the assembly by reversing the steps.
Forget it. I figured it out.
To replace the brake light on a 2002 Mitsubishi Space Wagon, first, open the rear hatch and locate the tail light assembly. Remove the screws or clips securing the tail light cover, then gently pull the assembly out. Disconnect the wiring harness and remove the old bulb by twisting it counterclockwise. Insert the new bulb, reconnect the wiring, and reattach the tail light assembly before securing it back in place.
you don't replace the tail light you just replace the bulb in it