0
To replace the water pump on a 1985 Dodge B-150 van, first disconnect the battery and drain the coolant from the radiator. Remove the serpentine belt, then take off the fan and shroud if necessary for access. Unbolt the water pump from the engine block, clean the mating surfaces, and install the new pump with a new gasket. Finally, reassemble everything, refill the coolant, and check for leaks.
What else can I help you with?
How do you replace a water pump on a 1988 dodge ram B150 3.9l V6?
Drain the water from your 1988 Dodge Ram cooling system. Remove the water pump belt. Remove the water return hose. Remove the water pump retaining bolts. Reverse the process to install your new water pump.
1989 dodge b150 compressor wiring their are two wires?
Power and ground
What is the Oil filter for dodge ram B150 1993?
Mopar part # 5281090
How do you replace the thermostat located on a 1996 Dodge Ram Van B150?
Loosen the alternator bracket, move it out of the way. The thermostat is at the end of the upper radiator hose where it curves into the engine
Where are the relays located in a 1994 dodge ram B150 van?
Under the hood by the latch in that black box.
What types of Dodge vans were made in 1989?
Dodge full size van b series B150,B250 all are rear wheel drive with 3 engines v6, 318,360
Where is the oil pump located on a 1983 Dodge Ram mini van B150 5.2 liter 8 cylinder engine?
In the oil pan.
Where is the oil sending unit located on a dodge ram 1993 pickup six cylinder engine you believe it is a b150 ram?
Back of the engine next to the distributor.
Where is the voltage regulator on dodge b150 van other than fire wall?
It may be an internal regulator in the alternator. The engine computer is also the voltage regulator.
How much does a 94 dodge ram van take on gas?
my 94 dodge ram van b150 has a 22 gal tank, gets 16/17 gal a mile city/hwy and gets about 352 miles to the tank
Is there a floor access plate to the fuel gauge sending unit in a 1985 B150?
No, there is not. You will have to remove the gas tank. But before you do you need to check power and grounds to the sending unit.
What is the valve cover torque specification for a Dodge Ram?
the chiltons manual for my 1990 B150 dodge ram van states 80 inch pounds. For a Ram 2500 with 5.9L Cummins 12 valve engine. The torque should be 18ft-lbs or 24Nm.
