To replace the front axles on a 1997 Mercury Villager, first, lift the vehicle and secure it on jack stands. Remove the wheel and brake components, then disconnect the outer CV joint from the wheel hub by removing the axle nut. Next, detach the inner CV joint from the transmission by using a pry bar to gently pop it out. Finally, install the new axle by reversing the disassembly steps, ensuring all components are secure and properly torqued.
To replace the drive axles on a 1994 Mercury Villager, first, lift the vehicle and secure it on jack stands. Remove the front wheels and the axle nut, then detach the lower control arm and any suspension components obstructing the axle removal. Pull the axle out of the transmission and the wheel hub, replace it with the new axle, and reassemble all parts in reverse order, ensuring everything is torqued to specification. Finally, lower the vehicle, replace the wheels, and check for proper function.
only 3, 2front,1rear is just a striaght axle bieng pulled by front wheel drive.
Cut it out and weld a new one in.
Simply raise the car and support the engine on a jack, then unbolt it.
how much to replace axles on a 2000 bravada
of what?
The distributor in a Mercury Villager is the round thing at the front of the engine with the six spark plug wires attached to it.
You will have to take out all of the parts to do this. Unless you have some experience with doing automechanics, it is a good idea to take it in.
Front wheel drive
Bottom front of engine.
It is on the front of the engine on the end of the crankshaft.
In front of the engine, down in the "V".