0
You have to take the trim panel off of the inside of the tailgate. Not just the removable section across the middle, but the whole thing. There are a series of screws that hold the tail light assembly to the back of the tailgate. You need to undo all of the nuts on the inside to release the tail light assembly, and be sure to unplug the harness as you remove it. The pressure switch is bolted behind the tail light assembly. Once you have the assembly out of the way, just fish the plug for the switch down and out with the switch. Change the switch and put it all back together.
What else can I help you with?
How do you remove and replace your door ajar sensor on your 2000 ford ranger?
Pull the door panel off, remove the door latch assembly from inside the door, and replace the switch which is hold onto the latch with one screw on the backside of the latch.
Where is the switch that controls the door panel light on a 2003 Volkswagen Jetta?
The door light switch for these cars is in the door latch. It is not visible by opening the door and examining the latch. If the switch is not functioning you will have to replace the latch. I have heard of cases when doors are slammed too hard that the wire connector comes loose.
How do you replace door ajar switch 2010 F-150?
To replace the door ajar switch on a 2010 Ford F-150, first ensure the vehicle is off and disconnect the battery to avoid any electrical issues. Locate the switch, typically found in the door latch assembly within the door. Remove the door panel to access the latch, disconnect the old switch, and replace it with the new one. Reassemble the door panel and reconnect the battery, then test the switch to ensure it functions correctly.
The rear hatch does not lock on 2002 rendezvous?
May be a BCM glitch or the rear trunk latch there is a recall from gm about the rear hatch latch
How do you fix a hood release bracket that holds the cable at the latch?
Replace it with a new or used one.
If the drivers door on a 1989 Accord will not open but everything appears to be connected how can you get the door open to replace the latch?
I have dealt with this problem before at our bodyshop. Basically, a spring inside the latch has broke, and now there is no way to release the latch, even by manually pulling on the release lever at the latch. Prepare to replace the latch, as it is not repairable. Be prepared to be working inside the car. To make it easier to work, unbolt the seat, and remove from the car. Remove the door panel, and also the door handle. You will have to chisel at the plastic part of the latch, and break it off bit by bit. Eventually you will be able to release the latch. good luck
Where might be the problem on your 1996 explorer interior light it wont turn off?
If the switch is concealed in the door latch--(common problem) Spray door latch liberally with WD40 open and close door many times--then spray with silicone should solve problem If not in door latch- could be faulty light switch or wire grounding somewhere in door switch remove, replace and check wiring
How do you replace the slide release latch spring on a savage model 30 shotgun?
Best left to a gunsmith.
How do you replace a door latch on an LG refrigerator?
What is a door latch mhahahaha lol Joking! Answer: Replace it with duct tape
How do you replace tail gate latch for a 2001 ford 150?
How do you replace the tail gate latch on a Ford f150
Your interior door latch on your 1997 Chevy silverado is not releasing the latch How do you fix?
Replace the door latch.
How can I replace a sliding glass door latch?
To replace a sliding glass door latch, first remove the old latch by unscrewing it from the door. Then, align the new latch with the existing holes and screw it into place. Test the latch to ensure it functions properly.
