answersLogoWhite

0

This procedure works for resetting the oil change reminder on most 2001, 2002, 2003, 2004, 2005 and 2006 Ford Explorer and Mercury Mountaineer vehicles that have the three vertically aligned buttons with "Info" on the top ,"Set up" in the middle and "Reset" on the bottom.

.

Close the door, turn the key on with engine off and wait for the chime to stops.

Press and release "Set up" until you see "Reset for system check".

Press and release "Reset" until you see "Oil life % Hold reset new"

Press and hold "Reset" until you see "Oil life reset to 100%"

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you change the turn signal bulb on a 2002 Ford Explorer xls?

You can change the light bulb by this method.


Where is the Fuel reset button 2002 ford explorer?

i have a 2000 xls and the reset is above the speedometer


Turn signal does not work on Ford Explorer?

2002 ford explorer turn signals not working


How to Change tire 2002 explorer?

how do you remove all lug nuts from a ford 2002 xlt explorer


How do you reset the outside temperature sensor on a 2002 ford explorer?

There isn't a reset, either the sensor, wiring, etc. is bad.


How do you reset the abs light on a 2002 Ford Explorer?

have vehicle scanned with ABS scanner to determine the problem


Where is the fuel reset button on a 2002 ford explorer located?

In the front passenger footwell , by the kick panel


Where is the fuel reset button on a 2002 ford explorer?

That should be in the right front passenger footwell , by the kick panel


How come you cant program your 2002 Ford Explorer remotes?

You might not be able to program your 2002 Ford Explorer remotes because you might not have turned the ignition to off and then run eight times. You must do this to reset the remote.


How do you reset the generic electronic module on a 2002 explorer?

To reset the Generic Electronic Module (GEM) on a 2002 Ford Explorer, disconnect the vehicle's battery by removing the negative terminal for about 15 minutes. This will allow the module to clear any stored error codes and reset its functions. After the time has elapsed, reconnect the battery terminal and start the vehicle to ensure the GEM has reset properly. If issues persist, further diagnostics may be necessary.


When to change 2002 Ford Explorer Timing Belt?

I believe the Explorer does NOT use a timing belt, but rather a timing chain


How do you change the brake light on a 2002 Ford Explorer?

pay someone else to do it