To rewire a 4L80E transmission harness to work with a 4L60E in a 1996 Chevy Silverado, you'll need to modify the wiring to match the 4L60E's pinout. Start by identifying the connectors and wiring colors for both transmissions, then splice the necessary wires accordingly, ensuring to connect the appropriate power, ground, and signal wires. Pay special attention to the transmission range sensor and shift solenoids, as these will require proper wiring adjustments. Finally, double-check all connections and consider using a wiring diagram for accuracy.
No, Not even close. The wiring harness in the 96 is all together different then the 91.
yes
YES they are the same.
It should be a TH700-R4
That would be a 4L60E trans.
It depends on whitch tranny you have. If it's a stick the switch is located on the right hand side of the tranny. If an automatic the switch is on the top of the tranny.
on the tranny in most cases
a 1983 silverado has an TH350, its a three speed tranny. its been said that it's the best transmission that gm has ever produced.
check beside tranny housing, should be a modual
put tranny fluid in it!
under the tranny pan to the rear of the pan
Yes the bolt pattern is the same. It will go right in there no problems.