The way on how to set the clock in your car, would depend on the tyoe of clock/radio in it. My first suggestion: check and see if it is the original clock/radio installed. If it is the "factory stock"(the clock/radio that it had when first built, sold, etc.), would be to check the owner's manual. On later models there will be a pair of arrow buttons labeled "Audio" that you can use to set the hours and minutes separately. Simply hold each one until the time begins to change. If, however, it has been replaced by a different clock/radio system, you are going to have to look up the kind installed into it. For better or futher advice, contact your nearest auto part/repair store. If you need a clock that bad...buy a watch!
how do you set the clock on a 2003 chevrolet trailblazer
Use the set buttons.
You hold the "rcl" button in and use the "seek/scan button for hours and minutes.
Turn off the radio and press the clock button. Use the adj dial to adjust the hour, press the clock button again to adjust minutes.
To change the clock on a 1990 Mercury Cougar, first, locate the clock or radio controls on the dashboard. Turn the ignition key to the "On" position without starting the engine. Then, press and hold the "HR" (hour) button to set the hour, and the "MIN" (minute) button to set the minutes until the correct time is displayed. Release the buttons, and the clock will be set.
Hold set button, Push seek for hours, push scan for minutes.
Turn the ignition key to the on position. Turn the radio off and press the set button. Set the hour and minutes using the seek buttons.
Power off raido, press the set button, use the seek and scan buttons.
Buy a GPS tracker and set it into car
To set the clock on a 2012 Chevrolet Malibu, first, turn on the vehicle and press the "Menu" button on the audio system. Use the knobs or buttons to navigate to the "Settings" option, then select "Clock." From there, you can adjust the time using the appropriate buttons to set the hour and minutes, and finally, confirm the settings to save the changes.
HI, You press the button that says "time set" over it then while holding that button, you press the "tune" button > for the minutes. Its the same basic way for all three types of radios for the '97 Tracker. I hoope this helps and good luck. Steve H.
To set the clock in a 1990 Buick Riviera, first, turn the ignition to the "On" position without starting the engine. Press and hold the "HR" button to set the hour, and then press the "MIN" button to set the minutes. Release the buttons once the correct time is displayed. Finally, turn off the ignition to save your settings.