0
Hey, I just changed mine. You can get a kit do do it. Or you get a nice size c- clamp, a deep well socket that is bigger than the u joint cap on one side and a deep well socket that is a little smaller than the cap on the other side. Use the c-clamp to press the one side into the other (larger) socket. Once pressed all the way through, you should be able to slip it out.
What else can I help you with?
Does a 1989 Chevrolet cavalier take a Fram PH8A oil filter?
No it does not.
What transmission fluid is required for a 1989 Chevrolet Beretta?
It will take dexron or mercon
How much horsepower does a 1989 Chevrolet 305 HO small block v8 have?
Some where around 260 give or take 5 or so due to wear.
How do you replace front driver side axle?
depends for what kind of vehical. IF it's a car, the axle is likely easy to do. IF it is a 4x4 truck with manual locking hubs, it's a lame job. if its a car, jack it up on the side the axel needs to come out , take the tire off, and everything else in the way including your brake. and slide the axle joint out , just take the whole thing out, its garbage now. Take the new one you bought. slide it in with grease and start putting it all back together. IF its a truck with manual locking hubs, you will want to jack it up with the tire off faswell, take the brakes off, and make sure you do not lose any of the bearings.. clipps.. spacers.. rings.. any of it, and remember the order you took them off in, as it is important to do so. once that stuff is all removed you have acces to your broken axel assuming it's broken at the UJOInt which is more common, slide it out, take the axel to a mechanic and have the ujoint compressed to come out. buy a new ujoint of the same model, have it pressed back in place of the axel, take the axel back home and slide it back into the front differential, and start putting everything back together!
How far does 26 gallons of gas take you on a 1989 Chevrolet pick up?
Well it depends on how you drive and which model. If you're on the highway somewhere around 416 miles, less in the city.
How do you change the front wheel bearings on a Mitsubishi mirage?
The bearings must be pressed out of the hub and the new ones pressed in. Take it to a garage
How do you change the front wheel bearings on a 2001 Mitsubishi Mirage?
The bearings must be pressed out of the hub and the new ones pressed in. Take it to a garage
How do you get the front axle out on the passenger side of a 1986 ranger 4x4 to replace the ujoint?
you have to start by pulling out the driver side then dropping the pod out of the center of the Dana 27 to take out the c clip then the axle should pull right out
What is 2010 take away from 1989?
To find the result of 2010 take away from 1989, you subtract 1989 from 2010. This calculation gives you 2010 - 1989 = 21. Therefore, 2010 take away from 1989 equals 21.
Do you have to remove the power steering pulley in order to remove the bracket on a 93 Chevrolet pickup with a 350 Does the pulley have a bolt in the center?
power steering pulley is pressed on. to remove pulley, u need to completely remove pump from vehicle and take it to a mechanic that has right tools for removing
How do you fix the problem on a 1989 Chevrolet Cavalier Z24 if when you push in the clutch it does not fully release so it is difficult to put in gear?
It can need a new slave or master cyl. TAke it to a garage as it is hard to bleed and to work on.
Does Fagan Chevrolet take discover card?
yes
