0
The 2004 Pontiac Sunfire typically has five bolts that secure the transmission to the engine. However, it's essential to check the service manual for the specific vehicle and engine option, as variations may exist. Always ensure proper torque specifications are followed during reassembly for optimal performance.
What else can I help you with?
How many bolts hold the transmission to the engine in a Honda motor?
9
How many bolts hold the transmission to the engine on a 1995 K1500 Z71?
6 bolts hold the transmission to the back of the engine.
How many bolts hold in a Camry transmission?
Yes, bolts simply hold in a Camry transmission. That's just a law of nature
How many bolts to mount transmission to a Chevy 4.3?
There are 6 bolts that hold the transmission to the 4.3L block.
How do you remove the top two bell housing bolts on a 1991 Toyota pickup?
you first remove the engine mounting brackets, then you place a jack under the transmission and remove the cross member bolts that hold the transmission up. after the bolts are removed you can lower the transmission down which will tilt the motor back allowing access to the top 2 bolts from the back side
How much transmission fluid does a 2001 Pontiac sunfire with a 2.4l engine hold?
1.8 qts
How many bolts hold the starter motor on a 1.3 vauxhall corsa 2005?
The starter motor on a 2005 Vauxhall Corsa 1.3 typically is secured by two bolts. These bolts are usually located on the transmission side of the engine. It's important to consult the vehicle's service manual for specific details or torque specifications when removing or installing the starter motor.
How many bolts hold in a grand voyager transmission?
6
When changing a transmission on a 1997 Pontiac Sunfire 2.2 is it easier to remove the motor or go through the bottom?
Its easier from the bottom (just make sure you use a engine support bar to hold the engine)
How do you tighten torque converter bolts on a Chevy 305 transmission?
pull the dust cover off the transmission and the converter bolts are easily accessable from there. there are three nuts and bolts that hold the converter to the fly wheel. probably 9/16 head bolts. turn the motor by hand until you see one.... tighten it and rotate motor again by hand until you see the next... tighten it and turn it to the third... tighten it and then reinstall dust cover
How many bolts hold the engine to the transmission on a 2000 Dodge Dakota?
6 bell housing to block bolts.
How do you replace a wiper motor on a 96 VW Jetta?
1) Remove wiper arms, pop off the small caps at the base of the arm and remove the nut, wiggle arm until free. 2)Remove wiper cowl. That black plastic cowl is held on with the plastic screws they are threaded but you may have to pry up on them gently while turning them out. 3) With the cowl off you can see the 3 bolts that hold on the wiper transmission remove those 3 bolts, disconnect the wires and pull out the assembly the motor will come with it. 4) a couple bolts hold the motor to the wiper transmission, remove them and the motor is free.
