The 1972 Ford Ranger pickup truck transmission holds 12 quarts of Transmission Fluid. The 1972 Ford transmission can only use a transmission fluid made for Ford transmissions.
about 12
In the Transmission
Dextron 2
AnswerDEXTRON III is what is needed for a 1972 Camaro.
Type F
To change the transmission fluid in a 1972 Buick Skylark, first, ensure the vehicle is parked on a level surface and the engine is off. Remove the transmission pan bolts and carefully lower the pan to drain the old fluid. Replace the filter and clean the pan before reinstalling it with a new gasket. Finally, refill the transmission with the appropriate type of fluid through the dipstick tube, checking the level as you go.
Engin compartmet drivers side ther should be an object take the lide off and you should see your brake fluid level.
It depends, if the unit,convertor,lines and cooler are all dry and the unit does not have the deep pan it will hold about 12qts. If you are just changing the fluid and filter only and it's not the deep pan about 4qts will do it.
Pull the dipstick handle out of it's holder and get a funnel that fits into the dipstick hole and fill it.
The front seal of the tranny needs replaced, the tranny will have to come out to replace it.
you have to drop the entire pan since there is no plug and you might as well change the filter and gasket while you have it off
Best to drain existing oil,measure it then add new trans oil. Better yet, use the right oil, which would be motor oil, not transmission fluid. The amount to use is stamped on the engine case. (850cc)