Good luck haha..
We have a 1998 V8 Olds Aurora, and it takes dex-cool engine coolant. It is the coolant that is orange colored. Wouldn't your small manual tell you the correct coolant to use?
To bleed the cooling system on a 1996 Olds Cutlass, locate the bleed valve, which is on the front of the engine above the water pump. After making sure the cooling system is not under pressure, open the valve by turning it counterclockwise. Fill the radiator with coolant until no air comes out the bleed valve, and a stream of coolant begins to flow from there instead. Tighten the valve and close the system to finish the job.
The coolant goes into the reservoir only that says coolant. You don't put it in the radiator.
Bad sensor? Should be located at the bottom of the coolant recovery tank
Check the sensor located at the bottom of the reservoir.
To bleed the coolant on a 1997 Olds Achieva, start by ensuring the engine is cool and remove the radiator cap. Next, run the engine with the heater set to maximum heat and let it idle until the thermostat opens, allowing coolant to circulate. As the coolant level drops, add more coolant to the radiator and keep an eye on the overflow reservoir. Once the coolant is circulating steadily and no more air bubbles are visible, replace the radiator cap securely.
i am replacing the starter on olds 1995 aurora
To bleed the cooling system on a 1996 Oldsmobile Achieva, first ensure the engine is cool. Remove the radiator cap and start the engine, allowing it to reach operating temperature. As the thermostat opens, air bubbles will escape; keep an eye on the coolant level and add more if necessary. Once the bubbles cease and the coolant is at the proper level, replace the radiator cap securely.
Trick question. there isn't a 94 olds aurora.
To disarm the security system on a 1997 Oldsmobile Aurora, simply press the red button on the key fob. If the key fob is not available, insert the key into the ignition and turn.
1,000,000#
1998 olds aurora altenator replcemnt