answersLogoWhite

0

30 Minute Learn Procedure

1. Turn ON the ignition, with the engine OFF.

2. Attempt to start the engine, then release the key to ON, vehicle will not start.

3. Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF.

4. Turn OFF the ignition, and wait 5 seconds.

5. Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes, the vehicle is now ready to relearn the Passlock™ Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK.

Important

The vehicle learns the Passlock™ Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle.

6. Start the engine, the vehicle has now learned the Passlock™ Sensor Data Code and/or password.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

The car will not start and the horn honks and lights flash; how do you reset?

wait 10 minutes for the passlock system to reset for a GM vehicle.


How to reset the passlock on 1998 Chevy 1500?

cut the yellow small wire from ign. switch in the column up by the switch. this is the passlock wire. but will it start iwas told that it wouldnt


Where is the fuel pump reset on a 94 s10?

It doesn't have a reset button.


Where is the reset button on a 99 Chevy S10?

The 99 Chevy S10 does not have a fuel pump reset button. The pump is controlled by the relay unit.


How do you reset passlock on a 2003 chevy impala?

To reset the Passlock system on a 2003 Chevy Impala, first, insert the key into the ignition and turn it to the "On" position without starting the engine. Leave the key in this position for about 10 minutes until the security light turns off. Then, turn the key to the "Off" position for a few seconds and repeat the process two more times. After the third cycle, the Passlock system should reset, allowing you to start the engine.


How do you reset passlock on 2001 Saturn?

Turn the engine two seconds then leave the key in the run position for exactly ten minutes...the anti-theft security light should go from blinking to solid at the ten minute mark. Immediatly run the engine and the Passlock is reset. Good Luck!!


Where is the fuel reset button for a 1986 S10?

Gm does not use reset/inertia switches.


Where is the fuel pump reset switch on a 91 s10 truck?

It doesn't have a reset switch.


How do you reset the fuel pump switch on a 86 s10?

There is no "reset" switch for the fuel pump on that vehicle.


How do you reset a car-lok anti theft system?

Depends on the vehicle and manufacturer. On GM Passlock, you have to wait about 10 minutes for the system to automatically reset before you try it with the key again.


Does the 1993 Chevy s10 have a fuel pump reset switch?

No.


Is there a fuel reset or computer reset on a 86 s10 blazer with a 2.8 and if so where?

There is a small button on the computer labeled "reset", press it.