just find your distributor behind your water pump and follow the spark plug wires. It is very time consuming and frustrating but you will save ALOT of money doing it your self
ac delco copper Use the factory recommended plugs. AC delco 41906.
any brand plug is fine. depends on what you want to spend on your spark plugs.
is there spark through the wires to the plugs?
To change the spark plugs in a 1993 Z28 with an LT1 engine, first, ensure the engine is cool and disconnect the battery. Remove the ignition coils and their mounting bolts to access the spark plugs. Use a spark plug socket and ratchet to carefully unscrew each old plug, then install the new plugs, ensuring they are properly gapped. Reassemble by replacing the ignition coils and reconnecting the battery.
To change the spark plugs on the passenger side of a 1995 Camaro Z28, first, ensure the engine is cool and disconnect the negative battery cable. Remove the intake duct to gain access to the spark plugs, then carefully detach the spark plug wires by pulling them straight off the plugs. Use a spark plug socket and ratchet to unscrew the old plugs, then install the new plugs, tightening them to the manufacturer’s specifications. Finally, reconnect the spark plug wires and the intake duct before reconnecting the battery.
i assume you pulled plugs and grounded them and lookesed for spark.look online and test coils with meter.
I believe 30 thousandths auto parts store should be able to tell you
Look on the rubber elbow coming off the throttle body. It's the only sensor that plugs into that elbow.
I just opened the Chiltons 1993-98 Repair Manual and it says the proper gap for the spark plugs should be .035 for the LT1 (VIN P)!!!! The gap on the 3.4L is .045!!!!! I know I have seen .050 before for the LT1 so I would double check with GM before setting the gap?
The 1974 Camaro Z28 with electronic ignition typically came equipped with AC Delco R43TS spark plugs. These plugs are designed to work effectively with the vehicle's 350 cubic inch V8 engine and electronic ignition system, ensuring optimal performance. Always refer to the owner's manual or a trusted automotive source for specific recommendations based on your engine's configuration.
96' z28 won't start because lack of spark. Could it be crankshaft position sensor? I just replaced distributor.
.050 95 Z28 only came with 5.7 LT1 motor.