0
that's easy i had the same problem i got it from Home Depot, you can also get it from Rona, Canadian tire or home hardware the price is actually not that bad too
Replacing both halfs of the door hinges on that 90 S10 is a big pain in butt job. Consider purchasing pin and bushing kits and restore your present hinges on the vehicle. Pin and bushing kits are available at your local auto parts store.
What else can I help you with?
Where can you buy door hinges for a 1992 Chevy S10 pick up?
No
How do you remove the door of a 1998 S10?
To remove the door of a 1998 S10, start by disconnecting the battery to prevent any electrical issues. Next, remove the door panel by taking off screws and clips, then disconnect any wiring harnesses. Support the door with a jack or have a helper hold it, then remove the hinges by unscrewing the bolts. Finally, lift the door off the hinges and set it aside.
Adjust door on s10 to close tighter?
You can adjust the striker pin on the door post with a torx socket. Also, if there is too much slop in the door hinges that can cause problems. The hinges can be repaired with door hinge pin and bushing kits from your local auto parts store.
How do you adjust the doors hinges on 1989 s10 blazer 4x2?
Because the hinges are welded in place, replacing the hinge pins and bushings should restore the door back to original position.
What is the cost to fix a sprung door hinge on a Chevy s10 truck?
free and you can do it yourself!!!! get a socket or 2x4 and open the door, place it in the hinge and pull the door closed on it to bend the hinges back, you'll have to experiment to get it right.
How do you change a 2000 s10 door hinges?
Difficult job to do in your driveway. The original hinges are welded in place both on the door and the cab pillar. The welds have to be drilled out and the new hinges are bolted in. The alignment is critical. The upper hinge halfs on the body side require removal of the dash assembly. There are kits available to rebuild your old hinges while in place. The kit comes with new pins and bushings. Either way you will need a door spring compressor to remove and replace the door spring. This tool is inexpensive and can be purchased from your local auto parts store for under $20.
How do you change the door hinges from the origanal weld on type to the replacement bolt on type on a 1996 s10?
BIG JOB! The welds have to be drilled out to remove the original hinges. The door side hinge half can be installed thru the inside of the door by removing the door panel. The post side hinge halfs are very difficult. The entire dash assembly needs to be removed to gain access to the upper hinge half.
Did 1984 Chevrolet S10 come with door speakers?
did a 1984 Chevrolet s10 come with door speakers
Does a 1985 s10's hood fit a 1990 s10?
yes
How do you replace the driver side door of a Chevy S10 blazer?
You didn't say what year you have but, later models require removing the door panel, disconnecting the wire harness, removing the detent spring and drive out the two hinge pins. The spring will need a special tool to replace. You don't want to replace the hinges unless you have no choice. The original hinges are welded in to the door and the cab. They can be replaced but it is a expensive job. In most cases you can replace the hinge pins and bushings to restore the hinges back to normal. The pins and bushings are available at your local auto parts store.
Will a motor from a 1990 s10 blazer fit in a 1995 s10 blazer?
Yes it will fit.
How do you replace a passenger side power mirror assembly on a 1995 S10 blazer. If you have to remove the door panel how do you do that?
how to remove the door panel of a 1995 s10
