what belt size to a 302 bypass for removal of smog pump and AC
A smaller belt
93.5 inches for the bypass
Unfortunately the Taurus needs the AC Pulley to turn the water pump you CAN get a bypass pully for 30 bux and use the same belt and routing but the shorter no AC belt will not work on that engine
To bypass the smog pump on a 1984 Corvette, you typically need a shorter serpentine belt, as the pump will be removed from the system. The exact belt size can vary, but a common replacement size is around 77 inches. It's always best to consult a repair manual specific to your vehicle or check with an auto parts store for the most accurate size for your setup.
You may not bypass a smog pump. It is a part of the vehicle's emission's control system and bypassing it is a violation of federal law.
Stock belt size is 102'' with the smog pump pulley. You will need a 94.5'' belt to bypass it. Make sure when you remove the pulley, that you put the three screws back in to keep the holes from rusting.
you can use a 920mm 6groove belt or a 36 inch 6groove belt maybe even 35
To bypass the smog pump on a 1991 Chevrolet Caprice with a 5.0L (305) engine, you typically need a belt that is approximately 3/8 inch shorter than the original serpentine belt. A common size for this bypass is around 77 inches, but it's always best to measure the current belt or consult a belt size chart specific to your vehicle to ensure accuracy.
This is just a guess so take it with a grain of salt. I would buy a belt for the s10 without air conditioning and just bypass the air conditioning pump.
its a hard belt to find if you take it to the auto parts store they just look at you funny the belt number is 820 k6
No you can not bypass the ac pulley but you can by a bypass pulley at the part store for about 40$. I just got one for my 2006 ford taurus the ac pump locked up and burned my belt it can take a while to put on but its worth it if you dont mind not having your ac working.
The belt that I used my my 1999 ford escort ZX2 is a 6K730 to bypass the A/C. when routing the difference is the belt will come from the power steering to the tension pulley to the crank then water pump and the rest is normal. I hope this helps