on my 1985 Lincoln Town Car i had to remove the dash and get back to the firewall and remove a panel on the firewall to get to it. good luck it is a pain.
how do u re-place a heater core for a 1984 Lincoln town car
To replace the heater core in a 1984-1989 Nissan 300ZX, first disconnect the battery and drain the coolant. Remove the dashboard and the center console to access the heater core. Detach the heater hoses from the core, unbolt it from the housing, and then install the new heater core by reversing the disassembly steps. Reconnect all components, refill the coolant, and check for leaks.
The heater core on a 1984 Cutlass Supreme is located under the blower motor on the passenger side of the car, under the hood. First you need to remove the blower, and the hoses connecting the heater core. Replace the core, re-attach the hoses, and put the blower motor back on.
in order to do that you have to remove the dash & all the lines going to the core i have a 90 model i just had some1 else do it cause its a ruff job!!!!
Look up under the passenger's side dash close to the kick panel, and you will see a heater case. there on the front is a removable cover, held on with several 7mm screws. Remove that cover, disconnect the heater hoses under the hood, and replace the core. Reassembly is in reverse order of removal.
YOU MUST REMOVE THE DASH AND THEN THE HEATER BOX, 82 MUSTANGS USED TO HAVE AN ACCESS PANEL BUT NOT YOURS, IT IS A LONG JOB IF YOU HAVEN'T DONE IT BEFORE
You have to take out the whole heater and air condiasioning system out and replace the new heater core in. When you replace the heater core, you firset have to put the air condiasoning system in then the heating system/ heater core. When you take the old systems out, you first have to take out the A.C then the heater.
To remove the heater core from a 1984 Oldsmobile 98 Regency, first, disconnect the battery and drain the coolant from the radiator. Next, remove the dashboard and any necessary components to access the heater core housing. Disconnect the heater core inlet and outlet hoses from the engine compartment, then unbolt and carefully remove the heater core from its housing. Finally, reverse the process for installation, ensuring all connections are sealed properly to prevent leaks.
On all chevys that year 1979-1988 It's Not Fun. Step 1. Remove heater hoses from core under hood. 2. Remove glove box door inside. 3. Take off all 5 heater mounting nuts under the hood. 4.Remove defroster hood on front of heater inside . 5 Gently pull heater unit back and down. 6. Remove all control cables from heater and mark them. 7. Then you can take heater core out of heater casing by removing 4 srews from case where core is. 8. remove front and back retainer straps from core. Reverse to put it back in.
The thermostat for a 1984 Lincoln Town Car is under the top hose inlet. The inlet is bolted to the top of the engine and is easy to remove.
take it to a pro
It is on the Right side of the Heater Core Covering.