0
Should operate at 180 > 185 F. for std set up. I have a 73 Satellite sebring with 400 4bbl & run std specs. Have accurate temp guage ( after market ) & she runs from 175 to 185, even in the 40 + degrees ( celcius ) heat we get here in Australia.
cheers
Garry
Adelaide , South Australia
What else can I help you with?
What is the firing order for a 1970 Plymouth roadrunner?
what is the firing order for a 1970 Plymouth roadrunner with a 383 engine
How much horse power did the Plymouth roadrunner with 383 engine have?
the 383 magnum engine roadrunner in 1969 had 335 horse, the 1968 383 roadrunner had 325 horse.
What engine coolant does a 1988 chrysler Plymouth use?
Green
What is the coolant capacity of a 1997 Plymouth Voyager 3.0 V6?
The 1997 Plymouth Voyager 3.0 liter engine coolant capacity is 5.5 gallons. The coolant should be at a minimum of 50 percent antifreeze.
How do you bleed cooling system after replacing the water pump on a 98 Plymouth breeze?
To bleed the cooling system after replacing the water pump on a 1998 Plymouth Breeze, first ensure the radiator is filled with coolant. Then, start the engine and let it run with the heater set to maximum to help circulate the coolant. Keep an eye on the coolant level, and as air bubbles escape, add more coolant to maintain the proper level. Continue this process until no more air bubbles are present and the engine reaches normal operating temperature.
What does the thermostat on a car do?
The thermostat in a car regulates the coolant temperature inside the engine. When the engine is cold, the thermostat is closed, allowing the heat from the combustion chamber to heat the fluid (coolant) in the coolant galleys in the engine block. Once the engine reaches an optimal temperature, the thermostat opens, allowing coolant to flow through the radiator. The thermostat then controls the flow of coolant to hold the engine at its optimum operating temperature, irrespective of engine load and operating condtions.
How does the coolant reservoir work?
when the engine is running and coolant will become hot to its operating temperature,the cooling system is under pressure,coolant will overflow and goes to coolant reservoir.when the engine goes cold coolant will go back to the rediator.
Where to locate where to put the coolant in the BMW x5?
The coolant for a BMW x5 is placed into the coolant overflow tank on the left side of the engine compartment. It should be filled to the full mark when the engine is at operating temperature.
What happens if engine coolant is put in while the car is off?
After coolant is added run vehicle to normal operating temperature and re-check coolant level
What is a 1969 Roadrunner 383 worth?
With standard options a 1969 Plymouth Roadrunner with the 383 engine in a low retail situation could be worth, $10,850. Average retail, $27,200. High retail, $48,600. It's all about condition and factory options.
What is temp coolant sensor?
The sensor is a means for the driver to monitor the operating temperature of the engine .
What components are responsible for coolant flow and controlling maximum operating temperature?
The primary components responsible for coolant flow and controlling maximum operating temperature in an engine are the water pump, thermostat, and radiator. The water pump circulates coolant throughout the engine and cooling system, while the thermostat regulates coolant flow based on the engine temperature, opening and closing to maintain optimal operating conditions. The radiator dissipates heat from the coolant, ensuring it remains at an appropriate temperature before returning to the engine. Together, these components help prevent overheating and maintain efficient engine performance.
