Its on the left side 15/16 six point socket to remove
you must remove the spedometer cable from the transaxle/ fill through here
I remove the transmission dip stick and insert a funnel to fill it right there.
Fill Your Boots was created in 1989.
Click on the link below for more information.
It is on the center of the rear of the transfer case.
On the side of the trans about half way up and in the middle, fill until some comes out.
on the bottom of the radiator there is a drain pug. remove it. let it drain into a container and properly despose of it. close the drain fill it up run your motor until warm and top it off
Under the Jeep on the upper side of the transmission you will see a plug. Normally the fill plug and drain plug located below the fill plug are on the driver's side. Remove this plug and fill it until trans lube runs out. It is now full. Caution: Be sure you use the correct lube. You will need a small hand pump to accomplish this.
On the back of the case there are two plugs that take a 10mm Allen wrench to remove. The top of the two is the fill plug, fluid should be level with the bottom of the hole.
Fluid is added down the dipstick tube.
Underneath the vehicle, upper drivers side of the transmission.