need to replace the fitting, or remove it and put some plumers tape on the threads
Just about all GM Quadrajet equipped cars have the brake booster mounting at the rear of the carb on the base plate. Should be a threaded fitting.
To safely transition a child from a car seat to a booster seat, parents should ensure that the child meets the height and weight requirements for a booster seat, typically around 4-9 years old and at least 40 pounds. The child should also be mature enough to sit properly in a booster seat, with the seat belt fitting snugly across their shoulder and lap. Parents should follow the manufacturer's guidelines for installing and using the booster seat correctly, and always make sure the child is securely buckled in before driving.
the "valve" stem fitting you're referring to is called a schraeder valve , and is for connecting a fuel pressure gauge to, as a means of checking your fuel pressure-typical fuel pressure should be about 35 psi.
they should have booster seats because you might get hurt only for 8 and down kids
There should be a BIG vaccume port just behind the carburetor that is screewed into the intake and that's where it goes. Some carburetors had a vaccume port on the back of them that had a medal line that screewed into the back of the carburetor and the booster hose slid onto it. It can go in either place.
With engine off--pump brake until all vacuum is exhausted With foot on brake start vehicle--brake pedal should drop
There should be a hole behind the top of the bumper in the body, right above the license plate. Take the jack crank handle and insert it into the hole, and match the end of the handle to the fitting. Then unscrew the fitting. The spare tire will slowly lower itself.
The legendary Six Samurai are a new archtype in the yugioh card game world that are coming out in the storm of ragnarok booster pack coming out feburary,9,2011 if you play yugioh with six samurais you should get these cards
Remove the battery. Once it is out of the way you should be able to see a vent hose coming off the top of the transaxle. Remove the hose from the fitting and then unscrew the fitting from the transaxle. This is where you add the oil.
Steps to be taken in order to properly install a wifi booster are, firstly to be sure of the area one would like the booster to be located in. Second, configure the booster in order for it to be able to connect to the wifi signal. After the booster has been configured, everything should be all set and it should work properly.
The best booster pack is Crossroad Of Chaos (in my opinion) I think you should get it.
no