The rear hub socket size for a Ram 3500 typically uses a 35mm socket for the axle nut. However, it's always best to verify the specific year and model, as there can be variations. For accurate maintenance or repairs, consulting the owner's manual or a repair guide is recommended.
The rear hub nut socket size for a Skoda Fabia is typically 30mm. However, it's always best to check the specific model year and variant, as specifications can vary. Using the correct size socket is essential to avoid damaging the nut or hub during removal and installation.
30mm
Mk1 Focus 29mm 235Nm
To remove the bolts on the rear wheel hub of a 1992 Saturn, you typically need a 13mm socket. However, it's always best to double-check with a repair manual or verify the size with a socket set, as variations can occur. Make sure to use a ratchet or breaker bar for better leverage when loosening the bolts.
it is a 29 mm hub nut socket
32mm
32mm
The hub bolts use a 14mm twelve point socket.
29mm on mine at the rear, had to order socket off the net cause it seems to be an unpopular size in shops. might need a breaker bar too, as its extremely tight!
The rear hub nut size for a Citroën C8 is typically 30mm. However, it's advisable to confirm this with the vehicle's manual or a reliable source, as specifications can vary depending on the model year and specific configuration. Always ensure you use the correct size and type of socket to avoid damaging the nut.
36mm
You will need a 35 mm socket.