0
What would cause a vehicles turn signals to turn on both turn signals at the same time like hazard lights?
Hope this helps
What else can I help you with?
Why doesn't the turn signal lights turn on but the hazard lights work?
If the turn signals on a car works but the hazard lights do not there may be a problem with the flasher switch. The flasher is located in the steering column, and a damaged unit can cause the lights to stop working.
What would cause the hazard signals and the turn signals not to work on an Audi A4 1996 1.8T?
Flasher is faulty.
What is the most likely cause of blown hazard lights fuse on a 199 Dodge Caravan?
Water is commonly getting into the hazard light systems
What would cause the turn signals not to work but the emergency lights to function properly when the bulbs and fuses all seem okay?
Possibility you may have a bad hazard flasher unit or turn signal switch. The cheapest route is to try to replace the hazard flasher unit as your first solution to the problem. Hazard flasher units should only cost you under $10 .
What would cause the hazard lights to come on on their own after the car is turned off?
The light control module could be the cause of hazard lights coming on after the car is turned off. There could be a problem that has caused this module to become wet and it is now not working correctly.
How do you fix the turning signal and the hazards on a 1998 aurora Oldsmobile?
To fix the turning signals and hazard lights on a 1998 Oldsmobile Aurora, first check the fuses related to the turn signals and hazard lights, as a blown fuse can cause them to malfunction. If the fuses are intact, inspect the turn signal relay, which may need replacement if it's faulty. Additionally, examine the bulbs for any burnouts and replace them if necessary. If these steps don’t resolve the issue, there may be a wiring problem that requires further investigation.
Would a 1998 Volvo v70 hazard flasher switch cause the turn signals to stay illuminated?
Yes. The relay that controls the turn signals is built in the switch.
Xterra 2002 why do your turning signals not work but your hazar lights work?
be cause your bulb is blown out
What would cause the turn signal lights on a 1992 Explorer to light up but not flash The emergency flashers work but the turn signals will not flash?
either a bulb or the signal flasher relay located on the fuse panel usually opposite the hazard flasher relay
Can you install a bad flasher?
Yes, you can install a bad flasher, but it may lead to issues with your vehicle's turn signals or hazard lights. A faulty flasher can cause the lights to malfunction, flicker, or not work at all. If you suspect that your flasher is defective, it's advisable to replace it with a functioning unit to ensure proper signaling and safety on the road.
What happened when your 1992 Accord was hit on the front driver side to cause none of the turn signals to work while hazard and driving lights work power is shown to all lights and it is not a fuse?
It sounds like the ground for the parking/turn signal circuit is bad on the damaged side. You mentioned sufficient power to all lights, I assume this applies to the parking/turn signals too. If this is not the case check the main fuse box for disconnected, pulled-out connections. Hope this helps,
What would cause the turn signals and hazard lights not to work on a 1995 Volkswagen Cabrio if the fuses are good the connectors are good and the bulbs are okay?
There is usually a relay for the flashers and turn signals. It is usually a round metal looking thing in the fuse box. This is usually the norm. I have never worked on this specific vehicle, but they are all simular. Good luck.Brad.
